AirTime AT15RM Installation Instructions

Browse online or download pdf Installation Instructions for Clock AirTime AT15RM. AirTime AT15RM 2 pages. Airtime at15r wall clock installation instructions

Print Page

Quick Start Steps

1. Install an AirTime ATX Series Transceiver (refer to Transceiver instructions).

2. Press the TRANS button on the front of the Transceiver to begin manual signal transmission.

3. Insert two (2) CR123A lithium batteries (included) in the clock's battery compartment.

4. Press the RESET button on the back of the clock for 2 seconds to begin "listening" for the signal.

5. The LED on the front of the clock flashes Green every two (2) seconds and reception starts.

6. When the signal is received, the LED will flash Green every second and correction will occur.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Wall Clock Installation Instructions

Model AT15RM