ATS Dental ITL500 Operation And Maintenance Instruction Manual - Page 12
Browse online or download pdf Operation And Maintenance Instruction Manual for Medical Equipment ATS Dental ITL500. ATS Dental ITL500 17 pages.
Print PageProblem: The central unit does not switch on.
Possible cause
•Power cord not connected properly
•Unit has not been switched on.
•Broken connections inside.
• Transformer damaged.
• PCB faulty.
• Filter supply defective.
• Power interrupted.
Problem: The display is not working properly
Possible cause
•Possible interference.
•Broken connections inside.
•Display damaged.
•PCB damaged.
Problem: The keyboard is not working properly
Possible cause
•Keyboard damaged.
•Broken connections inside.
Problem: The motor doesn't work
Possible cause
• Micro motor cable not connected properly
•Contrangle defective or not properly
calibrated.
•Foot pedal damaged.
•PCB damaged.
•Motor damaged.
•Connector pins and/or cable damaged.
Problem: The motor stops suddenly
Possible cause
•Keyboard and/or foot pedal damaged
•Broken connections inside.
•PCB damaged
Problem: The pump is not working property
Possible cause
•Tube not correctly inserted
•Tube damaged.
Problem: The pump stops suddenly
Possible cause
•Pump damaged/blocked.
•PCB damaged.
USER MANUAL Rev 25/05/2023
14." TROUBLESHOOTING"
Solution
Make sure the power cord is properly plugged into the electrical outlet and the
connector on the back of the unit.
Check the back of the unit to see that the on button has been pressed.
Immediately discontinue use of the device and contact your distributor, service center,
or the manufacturer directly.
Solution
Check to see if the central unit has been positioned too close to another electrical device
which can cause interference. In this case, move the interfering electrical device further
away from the central unit.
If you cannot find the cause of the malfunction, immediately discontinue use of the
device and contact dealer, the authorized service center, or the manufacturer directly.
Solution
Attempt to change parameters by using the foot pedal.
Contact your distributor, service center, or the manufacturer directly.
Solution
Check to see that the micro motor cable is plugged into the connector on the front right
of the central unit, disconnect and reconnect
Check the integrity of the Contrangle. Remove the Contrangle and perform calibration.
Attempt to start the Micro Motor by using the [Motor ON/OFF button] on the central
unit keyboard. If unit does not turn on, contact dealer, the authorized service center, or
the manufacturer directly.
Immediately discontinue use of the device and contact dealer, the authorized service
center, or the manufacturer directly.
Solution
Try to turn off the motor by pressing the [Motor ON/OFF] button on the keyboard or
by using the foot pedal.
If the motor will not turn off, immediately discontinue use of the device and contact
dealer, the authorized service center, or the manufacturer directly.
Immediately discontinue use of the device and contact dealer, the authorized service
center, or the manufacturer directly.
Solution
To verify the proper tube connection, follow the instructions on this DFU.
Check for damage along the tube, kinks, partial occlusions, etc. Arrange for immediate
replacement of the tube.
Solution
Immediately discontinue use of the device and contact dealer, the authorized service
center, or the manufacturer directly.
ATS DENTAL srl – 51034 Serravalle Pistoiese – Italy – www.atsdental.it – [email protected]
I TECH LITE
Page 12 of 16