Atten AT-2233 User Manual - Page 7

Browse online or download pdf User Manual for Power Tool Atten AT-2233. Atten AT-2233 9 pages.

Print Page

8.INSTRUCTIONS FOR USE

Always observe the safety instructions and applicable regulations.

Use only one hand to hold the tool, do not place your other hand over the air vents.

Prior to operation :

Mount the correct accessory for the application.

Set the desired air temperature.

8.1 Switching on and off

To switch the tool on, set the on/off switch to position Ⅰ/Ⅱ. Some smoke may be emitted

after switching on; this does not indicate a problem.

To switch the tool off, adjust the lowest temperature to cool off, then set the on/off switch

to position 0. Let the tool cool down before moving or storing it.

8.2 Temperature setting

Turn ON/OFF switch to Ⅰ/Ⅱ, depending on temperature you need. Press any of

the adjusting buttons and the heat gun will start to buzz. Now you can increase

or decrease the outlet temperature and air flow gradually by pressing the buttons

④. The LCD will display the temperature in digits and air flow in ladder pattern.

Temperature in digits increase or decrease by ever y 10

8.3 Stripping paint

Mount an appropriate accessory.

Set a high air temperature.

Switch the tool on.

Direct the hot air onto the paint to be removed.

When the paint softens, scrape the paint away using a hand scraper.

Do not strip metal window frames, as the heat may be conducted onto the glass

and crack it. When stripping other window frames, use the glass protection nozzle.

Do not keep the tool directed at one spot too long to prevent igniting the surface.

Avoid collecting paint on the scraper accessory, as it may ignite. If necessary,

carefully remove paint debris from the scraper accessory using a knife.

8.4 Stationary use

This tool can also be used in stationary mode.

Place the tool onto the workbench.

Secure the cable to prevent pulling the tool off the workbench.

Carefully switch the tool on.

Make sure that the nozzle always points away from you and any bystanders.

Make sure not to drop anything into the nozzle.

℃