Attero Tech unHX2D User Manual - Page 9

Browse online or download pdf User Manual for Recording Equipment Attero Tech unHX2D. Attero Tech unHX2D 18 pages. Dante-enabled hdmi audio de-embedder/embedder

Print Page
Notes for mounting: All connections to the unHX2D should be made before the power is applied.
Attach any audio sources that will be used to the analog audio inputs. The analog audio inputs are balanced, so
o
be sure to check what output type the source to be connected uses in order to find how to connect it correctly
(see Hardware Connections section).
Attach the outputs to the required audio devices. The analog outputs are balanced, so be sure to check what
o
input type the device to be connected requires in order to find how to connect it correctly (see Hardware
Connections section 0 for further details).
*Note: All Attero Tech products are tested using UTP cabling and it is recommended that UTP cabling be used when
installing them. STP cabling can be used for installation though care must be taken not introduce grounding issues into
the system by doing so.
When powering using PoE:
Attach the Dante port to a spare PoE-enabled port on a PoE switch using a CAT-5 cable or better. If a mid-span
o
injector is being used, connect a spare input port to the Dante network switch using a CAT-5 cable, and then
connect the corresponding output port to the Dante port of the unHX2D.
When powering using an optional external supply:
Attach the Dante I/F port to a spare port on the Dante network switch using a CAT-5 cable or better.
o
Attach the power supply to the power input jack and then power up the external supply.
o
If all steps are performed correctly, the power light on the front should be lit. Some of the status LED's may also be lit or
flashing.
If the Dante interface is being used, there may also be some activity on the unHX2D Dante Ethernet connector LEDs. If
the cable is connected and no network is detected, both LEDs will remain off. If an active connection is made both LEDs
will come on and if there is network activity, the yellow LED will then flash.
 Attero Tech LLC 2018
Page 9
unHX2D
User Manual
614-00038 Rev 01_a