DSYS DL16BW User Manual - Page 3

Browse online or download pdf User Manual for Lighting Equipment DSYS DL16BW. DSYS DL16BW 12 pages. Rc led lighting

Print Page

Connect the S1 switch or the cable

plugged into the free channel of the

receiver to the CH3 connector.

Solder the wires to connector's counterparts. Cut the LEDs lead to 5mm

length, extend the leads with wires and isolate them properly.

The types and colours of used LEDs can be

combined.

LED polarity: flat side (usually shorter

lead) is negative (Cathode).

Powering LEDs from the Receiver (+5V). Connect the LEDs

cathodes to L1-L8 (A, B) connector pins. Connect the common

LED's anodes to +L (A, B). The + L (A, B) terminals are internally

connected. Do not connect any resistors to LEDs. The outputs

provide 20mA current.

You can connect one 3V LED (white, blue) or two red

2,1V LEDs. By connecting the K2 outputs (e.g. L1A with

L1B) the current

powerful LEDs !) You can connect any of L1-L8 A, B outputs.

When the voltage drops under 5V the LEDs light intensity decrease.

LED Powering from Driver Battery

Connect all LED anodes to positive (+) battery pole.

If you use standalone battery to power the LEDs then connect its

negative pole to the K1 connector G pin.

The maximum number of connected LEDs is determined by the

battery voltage per formula: Uaku -0,6-(n x Uled). Uaku= battery

voltage, 0,6V=stabilization, n=number of LEDs, Uled=LED voltage.

The calculated value must be between 0 - 5 (otherwise its overloaded).

Example 1. 8x NiMH (8 x 1,2 = 9,6V), 3 LED 2,1V in series.

Calculation: 9,6-0,6-(3 x 2,1) = 2,7. 3 LEDs can be used.

Example 2. 3S Li-Pol (3 x 3,7) = 11,1V), 4 LEDs 2,1V.

Calculation. 11,1 - 0,6 - (4 x 2,1) = 2,1. 4 LEDs can be used on one

output.

is increased to 40mA (Only for

(connection see page 4 - footlights).

Cable CH3

CH3

-C

Switch S1

-C