DTA INCLISAFE IS1 User Manual - Page 6

Browse online or download pdf User Manual for Tractor Accessories DTA INCLISAFE IS1. DTA INCLISAFE IS1 8 pages. Specific for tractors

Print Page

2) Configure your INCLISAFE device using the INCLISOFT software provided. Read the

INCLISOFT Installation and User Guide that you will find inside the INCLISFE packaging box.

INSTALLING THE INCLISAFE ONBOARD

The INCLISAFE device installation inside the tractor cabin is very simple. Follow these steps:

1) Find a nearly horizontal surface inside the tractor cabin. It does not need to be completely

horizontal, since the device allows for a ±10º maximum installation inclination. INCLISAFE is

usually installed below the driver's seat or even behind it.

2) Clean the surface with a wet cloth, and dry it carefully. In this way, the maximum adhesive

strength is achieved by the Velcro® adhesive.

3) Place the INCLISAFE device on the chosen surface. The device orientation is quite important.

It has to be placed in a way that the arrow on the INCLISAFE surface is oriented along with

the longitudinal direction of the tractor. Use the provided Velcro® strips to fix the device to the

horizontal surface.

4) Connect the 12V power supply cable to the 12V power supply output inside your tractor cabin.

Afterwards, connect the power supply cable to the INCLISAFE input connection. After an

instant, you will hear a beep. This beep means the INCLISAFE device is properly installed.

Important: If INCLISAFE is installed with an inclination higher than 10º, you will hear an

intermittent beep when you plug it in, which won't stop until it is unplugged. This means that

you have to install the device on a more horizontal surface.

5) Once the INCLISAFE device is plugged in, you need to re-calibrate the device so that it takes

the installation position as the tractor horizontal reference. To do so, press and keep pressed

the RESET button for a few seconds, until you hear a short beep sequence. This means the

device has been re-calibrated correctly.

If you have gone through these steps correctly, you now can start working with your tractor using

the INCLSAFE device.

REMEMBER: INCLISAFE measures not only the inclination but also the dynamics, the effect of

the bumps on the tractor. This implies that INCLISAFE will emit the alarm when it detects hard

bumps, indicating that these bumps involve a stability loss. Therefore you should avoid them or

drive at a lower speed around these bumpy areas.

INCLISAFE FOR TRACTORS – USER MANUAL