DTC HVT User Manual - Page 4

Browse online or download pdf User Manual for Transmitter DTC HVT. DTC HVT 20 pages. Portable day/night camera and digital cofdm transmitter

Print Page

QUICK START

Accessories

• Shipping Case w/Quick Guide

• Extra Battery Pack

• Battery Chargers (2):

• Connect to Battery (External)

• Connect to Flashlight (Internal)

• External DC Power Conditioner

w/Cigarette Adapter

• Programming Cable

• Programming CD

• User Manual

• Lens Cleaning Wipes

• Lens Cleaning Cloth

• Silicon O-Ring Lubrication

HVT Shipping Case

DTC COMMUNICATIONS, INC.

1. Make sure the antenna is connected to the transmitter.

2. Be sure to start each mission with a fully-charged battery pack.

See Charging the HVT battery pack (page 5). The RED LED blinks

when the battery is low. If using alternative power source, connect

through Ext. DC Power Source module supplied.

3. Select the Channel on the transmitter that matches the frequency and

settings of your receiver or repeater receive Channel.

For programming instructions, see Programming on pages 10 to 15.

4. Unlock the Main Power Switch. Set the Main Power switch to LEFT for

illumination, or RIGHT for camera TX only.

5. To operate the spotting laser, press the Laser ON/OFF Button. An LED

in the button indicates ON/OFF State. The laser spots for

approximately 30 feet, placing a dot in the center of the image. The laser

produces a beam strength of less than 5 mW and is blink safe.

WARNING: Do not apply power to the transmitter unless an antenna

or non-radiating load is connected to the Antenna SMA connector.

WARNING: Do NOT connect external DC power sources directly to

the HVT. Connect all external DC sources through the supplied

Ext. DC Power Source module. (Examples: car battery, customer-

supplied battery, etc.)

NOTE: Ensure the Zoom Retainer is plugged-in to the

Monitor Zoom connector

to ensure a 1:1 zoom

setting. (See Page 7.)

Otherwise, the zoom

setting is not controled.