bouncepad Click Assembly Instructions

Browse online or download pdf Assembly Instructions for Racks & Stands bouncepad Click. bouncepad Click 2 pages.

Print Page
CADDY
Assembly Instructions
Unless specified, instructions are
for both Eddy and Click stands.
Tools Required to Fix From Below:
Drill
5mm Drill Bit
Pencil
Sheet Code:
BP-IM-070_REV2_Combined
Release Date:
18/05/2022
Copyright 2020 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
tie
Insert the tie through the grill and
2
then clasp over the device.
* Keep sufficient slack
to allow Eddy/Click to
rotate freely.
Wrap the charge cable around the
5
clips and plug into the power source.
1x Caddy
Fixings Kit
1x Drilling
Template
4x clips
1x tie
In the Caddy Box
USB hub or battery pack
full list of
supported devices
available at
bouncepad.com
Insert the cable management clips
3
into the grill, then twist to secure.
Basic setup is now complete. To add
security features follow steps 7 onwards.
receipt printer
full list of
supported devices
available at
bouncepad.com
card reader
Additonal devices are connected
6
by repeating step 2.
T20 torx
allen key
4x M4 split
washer
2x 80mm
grub screw
4x M4
wing nut
Fixings List
* Due to the modular nature of
our product range you may receive
additional fixings in the fixings kit
clip
4x M4 flat
washer
Click manual
Steps A2+C1
4x M4
buttonhead
screw
Complete separate Eddy
1
or Click manuals until
steps shown above.
Feed your Eddy/Click charge cable
4
through the channel.
Eddy Only
bung
Lift up the Eddy Stand and remove
7
bungs and OUTER half-bungs from
Caddy.
Eddy manual
Step 6
half-bung