Attonic ARFS-50 Operation Manual - Page 10
Browse online or download pdf Operation Manual for Test Equipment Attonic ARFS-50. Attonic ARFS-50 13 pages. Arfs-series digital force gauge
■Explanation of a button setting function (2)
Push F button
④ Set up Comparator Function (LO)
Set up the low limit of comparator function. Figure rising
by D-button and Digit rising by RESET button. When not
using this function, setting to the 0.
(Initial setting : 0)
Push F button
⑤ Change Measuring Unit (UN)
To push D button, display change from N→Kgf→lb f→
N・・・ (Initial setting : N)
Push F button
⑥ Set up Overload (OV)
Count up by D button. Figure up by RESET button.
Setting value is %.
When not using this function, setting to the 0.
(Initial setting : 0) In case of setting 0, " OVER LOAD "
will be indicated on display when the load is reached from
100% to 110% of full scale.
Push F button
⑦ Set up Power Auto Off(AP)
To push D button, Set up the Power auto off 1→release 0・・・
(Initial setting : 1)
Push F button
⑧ Set up Number of Digits on display / NP setting (NP)
Push "D" button.
If you need 3 digits on display, please set"1".
If you need 4 digits, please set " 2 ".
It is possible to change number of digits by this function.
Push F button
⑨ Reverse Digital Display
The Value becomes flashing & dark. To push D button, the
direction of display indication is reversed in upside down
position.
Push F button
TO ① Change Peak Hold (PEAK) and Tracking (TRUCK)
Keep to push F button about 6 seconds, the gauge is now
ready to measure.
↓
↓
It cannot set under 0.
↓
↓
↓
↓
-9-
ATTONIC