Attwood 91020 Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Marine Lighting Attwood 91020. Attwood 91020 2 pages. Attwood plastic stowaway light base installation instructions

Print Page

FINAL WIRING FOR:

91020, 91022 (2 wire base): Connect one black wire to the battery

ground (-) harness, using a crimp-on wire connector. Attach the

remaining black wire to the positive switched wire from the navigation

light switch.

91021 (3 wire base): Connect black wire to the battery ground (-)

harness, using a wire connector. Connect the blue wire to the wire

from the switch for the courtesy light. Use a wire connector to make

the connection. Connect the gray wire to the wire from the switch for

the navigation running lights using a wire connector.

All positive wires must be fused according to light specs to protect

the circuit. MAKE SURE POWER SOURCE IS 12-VOLT D.C. ONLY.

HIGHER VOLTAGE CAN CAUSE DAMAGE TO LIGHT AND WIRE

CIRCUITRY.

Insert light pole into base and press down to make contact. Insert

lock collar into base opening, rotate if necessary to push it down into

base. Rotate collar until tight to hold light pole in base. Test light

operation. Remove and stow light. Close cover to protect contacts

when not in use.

Part #91020, 91021

Part #91022

This product carries the standard Attwood one-year limited

warranty. See product catalog for details.

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com