ADDCOM ADD-665 User Manual - Page 13

Browse online or download pdf User Manual for Headsets ADDCOM ADD-665. ADDCOM ADD-665 18 pages. Dect headset with usb

Print Page

8.1.2 receiving an incoming call in telephone mode

•

If there is an incoming call from the telephone line and the headset base is

connected to a handset lifter or electronic hook switch device, the PC/TEL selection

(10) and in-use indicator (2) will flash, also a ring tone will be heard on the headset.

•

Lift the headset from the base to answer the call. If you are already wearing the

headset press the call hook button (17). The base in-use indicator (2) will light. If a

handset lifter or electronic hook switch device is connected to the headset base, the

line will be seized. Otherwise, you will also need to activate the headset port via your

telephone terminal.

•

To end the call, replace the headset on the base or press the call hook button (17).

8.1.3 making an outgoing call in pC (voip) mode

•

Ensure that the PC/TEL selection (10) on the base unit is selected. The PC/TEL

indicator (4) will light.

•

Lift the headset from the base or press the call hook button (17) if you are already

wearing it and the base in-use indicator (2) will light.

•

After finishing your VOIP call, press the call hook button (17) to disconnect.

8.1.4 receiving an incoming call in pC (voip) mode

•

Lift the headset from the base to answer the call. If you are already wearing the

headset press the call hook button (17). The base in-use indicator (2) will light.

•

After finishing your VOIP call, press the call hook button (17) to disconnect.

8.1.5 Adjusting the microphone volume

You can adjust the microphone volume by pressing the buttons on the bottom of the base

station (12).

8.1.6 muting the headset microphone

To mute the headset microphone when on a call, press the wheel on the headset to mute

(15). Press again to release the mute.

8.1.7 Adjusting speaker volume

Swipe the wheel on the headset to adjust the receive volume on your headset (14).

8.1.8 Adjusting compatibility switch

Select '1' or '2' until a dial tone is heard (13).