DTM Print Primera AP550e Quick Start - Page 2
Browse online or download pdf Quick Start for Industrial Equipment DTM Print Primera AP550e. DTM Print Primera AP550e 2 pages. Label applicator
Print Page
B
Load Label Stock
5. Place the label roll on the Roll Bar as shown. For narrow rolls you may have to flip guides so
the "L" faces away from the roll on each side.
6. Place the Roll Drag Arm under the Roll Bar so that the rounded tip is near the center of the roll.
7. Place the Roll Bar with labels on the pins so that the bar is fully seated on the pins.
8. Remove approximately 38 cm of labels from the liner.
labels facing up
holes to the rear
9. Load the label stock according to the diagram below:
Label Path
Liner Idler Roller
Roll Guides
Roll Bar
38 cm
Roll Drag Arm
Liner Drive Roller
Label Guide Roller
Application Roller
Peel Edge
10. Align the leading edge of the label
stock with the roll as shown.
11. Make sure the labels will be fed under
the Sensor Location Line.
12. Move the Guide Collars so they are
close to, but not pinching the label
stock.
13. Lock the labels in place by pushing up
on the metal Liner Idler Roller. Make
sure there are no labels past the Liner
Drive Roller.
Lock
Unlock
14. Move the Application Arm to the appropriate height by squeezing
the Pin Release Bar and pulling up on the arm.
Label Path
Liner Drive Roller
Label Guide Roller
Liner Idler Roller
Application Roller
Peel Edge
Pin Release Bar
Distance from
label stock to arm
side plate should
be equal in these
locations.
Sensor Location Line
Liner Idler Roller
Liner Drive Roller
no labels here
Position
Container Height
Notch 4
15-20 cm
Notch 3
10-15 cm
Notch 2
5-10 cm
Notch 1
0-5 cm
Pin
Align Here
Guide Collars