Auber WS-1500ES Operation & Instruction Manual - Page 6

Browse online or download pdf Operation & Instruction Manual for Temperature Controller Auber WS-1500ES. Auber WS-1500ES 18 pages. Precision pid temperature controller

Print Page

Fig 3b. How to remove the sensor.

3) Operating the controller

3.1 Setting the temperature.

Press SET key twice. Both 1) and 2) will start to flash. The LED shows the current

temperature setting. Use "+" and "-" keys to change the setting. When finished, press the

SET again to confirm the change.

Note: the temperature setting will not be changed if SET is not pressed (confirmed). The

display will return to the normal display mode if no key is pressed within 3 seconds.

3.2 Switching the display between temperature and time.

This is done by pressing the Time Key ("6)") once. When "8)" is on (lit) and "9)" is flashing

at the same time, LED is in timer mode and shows the actual time passed since the

controller was last powered on. When "8)" is off (not lit), LED is in temperature mode and

shows the current sensor temperature.

3.3 Setting the timer.

Press SET key once and release it, both 1) and 8) will start flashing. The LED shows the

current timer setting in minute. Use "+" and "-" key to change the timer setting. When

finished, press the SET again to confirm the change.

Note: the timer setting will not be changed if SET is not pressed (confirmed). The display

will return to the normal display mode if no key is pressed within 3 seconds.

Using the timer The timer can be used in two different ways.

a) Use it as timer. If you set the timer for 1200 minutes, the controller will stop sending