Auber WSD-1203CPH Operation & Instruction Manual - Page 2
Browse online or download pdf Operation & Instruction Manual for Temperature Controller Auber WSD-1203CPH. Auber WSD-1203CPH 12 pages. Programmable pid temperature controller with dual probe
Print Pageappliance or even cause a fire.
This controller is designed to control the devices recommended by Auber
Instruments only. Using it to control a non-recommended device can be
dangerous and cause fire. Auber Instruments is not liable for damages caused by
misuse of the controller. If you are not sure the controller can be used, please
contact Auber Instruments before use.
If an abnormal display or noise is observed, turn the controller off, unplug the
power cord and contact the manufacturer before using it again.
Clean the controller only when it is cool and unplugged.
Do not allow children to operate the controller.
Operating Instructions
1. Description of the controller.
1) TEMP1, Left window - During normal operation, it displays the temperature values
of probe 1. When the high or low limit alarm of probe 1 is on, this window will flash
between the alarm type (AH1or AL1) and the temperature. In the parameter setting
mode, it displays the controller's system parameters.
2) TEMP2/TIME, Right window - During normal operation, it displays the
temperature value of probe 2 (food internal temperature probe) or the time passed
since the controller was powered up. When the high limit alarm of probe 2 is on,
this window will flash between AH2 and the temperature. In the parameter setting
mode, it displays the value of the parameter.
3) Output status indicator - This LED indicates the output status that should be
synchronized with the heater. When it is on (lit), the heater is powered. When it is
off, the heater power is off. When it is flashing, it means the heater is on and off
Figure 1. Front Panel
2