Auber Instruments AW-HD330 Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Controller Auber Instruments AW-HD330. Auber Instruments AW-HD330 5 pages. Dual output programmable humidity controller

Print Page

AUBER INSTRUMENTS

10. Quick Operation Guide

•

If you see "Err" message in the display window, check the sensor and

sensor cable connection.

•

To run the program: if the controller is in Hold or Stop mode, press the

START key. The RUN indicator should be lit up.

•

To hold the program: when the program is running (RUN indicator on),

short press the PAUSE key to put the program on hold.

•

To stop the program: put the program to Hold mode, then long press the

STOP key for 4 seconds until you see "Stop" in the display window.

•

To set up program steps: press the SET key.

•

To set up system parameters: long press the SET key for 2 seconds.

•

To mute the alarm: press the MUTE key.

•

To check the current step number and the step running time: in the

Program Run Mode, press the STEP key once, the display will show "P-X",

where X is the current step number, then the display window will show the

elapsed time in the current step.

•

To check the total time since the controller is powered up: in the Program

Run Mode, press the STEP key twice. The display window will show "toL" and

will display the total time since controller is powered up.

•

To start from a specific step (or jump to a specific step): when the program

is on hold or stopped, press the STEP key once, and it will show "J-X"(where X

is the current step number). Use the UP or DOWN keys to change the step

number to the desired value, then press the START key to confirm. The display

will show JMP ("JUMP") for a second and then the controller will start

executing the specified program step.

11. Connect the Sensor to the Controller

The connector of sensor contains a slot for fitting pin connection. It also has a

spring lock to prevent disconnections from accidental pulling on the cable.

To install the sensor to the controller: 1) Identify the key on the male sensor

connector (Figure 5, a) and the notch on the female connector (Figure 5, b). 2)

Hold the tail of the female connector, align the notch and the key, and push the

female connector forward.

To remove the connector, hold the spring loaded collar on the female

connector and pull it back. Please see Figure 6.

2022.01

(a)

No part of this datasheet shall be copied, reproduced, or transmitted in any way without

the prior, written consent of Auber Instruments. Auber Instruments retains the exclusive

rights to all information included in this document.

WWW.AUBERINS.COM

Figure 5. Install the sensor.

Figure 6. Remove the sensor.

Auber Instruments

5755 North Point Parkway, Suite 99

Alpharetta, GA 30022, USA

www.auberins.com

(b)

(c)

P5/5