Auber Instruments KIT-CUBE2S Installation Manual - Page 15

Browse online or download pdf Installation Manual for Controller Auber Instruments KIT-CUBE2S. Auber Instruments KIT-CUBE2S 15 pages.

Print Page

Auber Instruments

6. Testing.

Before closing the enclosure with bottom plate, you can do a simple test with 240V input power

and load. For example, wiring a 220V light bulb to test the heater output and use a 120V lamp to

test the pump output.

The EZBoil DSPR320 has initial status to be stop; one needs to press the run button once to start

heating. And please remember to plug the sensor while testing.

In the case if there is no power from the heater outlet, please check SSR indicator and controller

OUT light action; they should work synchronously.

If no power from the pump outlet when switch is at ON position, please check if fuse has been

placed first.

After test, apply hot glue or silicon sealant for controller and the 5‐15R pump outlets; these

parts do not come with mounting screw, so they may go loose after time.

In the end, close the enclosure by fastening the screws on the bottom plate and you can enjoy

brewing with it.

Appendix. Tools Recommendation



Philip screw driver sets.



Flat head screw driver sets.



Ruler and caliper.



Tweezer



Wire cutter.



Wire stripper.



Wire crimper.



Hot gun or multipurpose sealant.



Multimeter.

No part of this manual shall be copied, reproduced, or transmitted in any way without

the prior, written consent of Auber Instruments. Auber Instruments retains the

exclusive rights to all information included in this document

v1.2

Auber Instruments Inc.

5755 North Point Parkway, Suite 99,

Alpharetta, GA 30022

www.auberins.com

Tel: 770‐569‐8420

6/12/2019