Auber Instruments AT210-A Notes On Use - Page 2

Browse online or download pdf Notes On Use for Thermometer Auber Instruments AT210-A. Auber Instruments AT210-A 2 pages.

Print Page

Auber Instruments, Inc.

www.auberins.com

For example, two of the thermometer (AT210-A) units have their ID number set as "001" and "002" respectively.

The remote unit (AT210-B) is currently receiving temperature reading from thermometer unit "002". So, the

thermometer unit "001" is currently NOT paired with the monitor (AT210-B). When this thermometer unit "001"

is switch off and then switched on again, the temperature reading jump to around 2223°F with the sensor

plugged in (Note: press the SHIFT ">" key the mute the buzzer.), or show -20°F if the sensor is unplugged.

However, this error is temporary and it can be fixed by following the steps below.

To fix this issue:

1) Switch OFF the monitor unit (AT210-B) by unplug its power cord.

2) Then, cycle the power to the thermometer (AT210-A) unit whose reading is erroneous. The temperature

reading should go back to normal.

3) Switch ON the monitor unit again by plugging in the power cord. Now, the system should work correctly as

before.

Special Note

The AT210 system is designed to use one monitor unit (AT210-B) to read from one or more thermometers

(AT210-A). Other combinations are NOT recommended NOR supported. Using two monitors (AT210-B) and two

thermometers (AT210-A), i.e., two sets of AT210-COMBO, can result in communication failure and all units won't

be able to function properly.

(However, in only one special case, where there are two monitors (AT210-B) and only one thermometer (AT210-

A), the system can work fine most of the time. Both monitors can receive temperature reading from the

thermometer, but occasionally they will lose connection and show "----". Usually, the readings will repopulate

shortly. )

Please

for any question during the troubleshooting process.

(End)

Auber Instruments

5755 North Point Parkway, Suite 99

Alpharetta, GA 30022, USA

www.auberins.com

E-mail: [email protected] Tel: 770-569-8420

No part of this manual shall be copied, reproduced, or transmitted in any way without the prior, written consent of Auber Instruments. Auber

Instruments retains the exclusive rights to all information included in this document.