Conair SB1C Instruction Manual - Page 6
Browse online or download pdf Instruction Manual for Hair Dryer Conair SB1C. Conair SB1C 8 pages.
Print PageOPERATING
INSTRUCTIONS
This appliance is intended for household use
only. Use on Alternating Current (60 hertz)
only. Standard Dryers are designed to oper-
ate at 110 to 125 volts A.C.
This appliance has a polarized plug (one
blade is wider than the other). As a safety fea-
ture, this plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt
to defeat this safety feature.
HOW TO SET UP AND USE
YOUR SOFT BONNET DRYER
1. Open the door on the side panel of the Soft
Bonnet Dryer. Pull out the line cord, the hose
and the bonnet.
2. To fully extend the hose, press the release
button on the hose to loosen the locking
mechanism.
3. Attach the bonnet to the hose by lining up
the protrusions in the hose locking ring with
the indentations in the bonnet locking ring.
Twist slightly to lock.
4. Place Soft Bonnet Dryer flat (not standing
up like a purse) on table or countertop.
Connect power cord to outlet.
5. Place bonnet over hair, pull drawstring
comfortably tight and lock in by pushing
locking mechanism button and sliding close
to the metal ring in the bonnet.
6. Turn Soft Bonnet Dryer on. High setting is
best for very wet hair; medium and low set-
tings are for more gentle drying or touch-ups
on hair that has been lightly misted with
water. Drying times vary with heat settings
and different hair types; you will soon learn
which heat setting and timing works best for
your hair. For best curl results, turn the dryer
to the "cool" setting for a few minutes at the
end of your drying time. Cool air sets curls
for long-lasting results.
7. To use concentrator or vent brush for pre-
cision drying and styling, unlock the bonnet
from the hose and attach the concentrator or
vent brush by lining up the lines on the lock-
ing rings of hose and attachment. Slightly
twist clockwise to lock. Use the concentrator
as you would use a concentrator on a regular
hair dryer and use the vent brush for preci-
sion styling.
8. For hot conditioning treatments, follow the
directions of the treatment manufacturer.
Generally, the conditioning lotion or liquid is
distributed in the hair and heat is applied until
the desired conditioning has been achieved.
9. After use of bonnet, push the locking
mechanism button again and pull away from
the bonnet to unlock the drawstring. Take
bonnet off and unlock it from the hose. Let
bonnet and hose cool down for a few minutes
until they are no longer warm to the touch.
Then fold the bonnet and store it in the dryer
housing. Push in the easy lock button on the
hose while at the same time pulling the draw-
string: the springy hose will conveniently