Dametric TVD-M3 User Manual - Page 7

Browse online or download pdf User Manual for Monitor Dametric TVD-M3. Dametric TVD-M3 8 pages. Touchpoint vibration monitor

Print Page
Dametric TVD-M3 User Manual
Dametric
5.

CONNECTION

The cables are connected to the detachable
screw connectors at the bottom of the unit.
5.1 K1 - POWER SUPPLY
TVD-M2:
115-230 VAC Mains Voltage
Live
K1/1
Neutral
K1/6
TVD-M3:
24VDC Mains Voltage
Plus
K1/1
Minus
K1/4
5.2 K2 - ALARM OUTPUTS
Function
normally
closed
Limit 1
K2/1
Limit 2
K2/4
Explanation. The above describes the state
of a not active output.
When the output is active (the led is lit and
the touch point level is lower than the limit
level)
the normally open contact is closed to the common contact.
5.3 K3 - LOGIC INPUT, TRANSDUCER, SIGNAL OUTPUT, GROUND
K3/1-2
Logic input, production
K3/1
Close this input to initiate production mode
K3/2
The input must be free from foreign potential
K3/3-5
Transducer signals
K3/3
Transducer +
K3/4
Transducer -
K3/5
Transducer, cable shield
K-TVDS25: Connect the shield to K3/5.
K-VIMS25: Isolate the inner shield. Connect the outer shield to K3/5
K3/6-8
Signal current output
K3/6
+ 4-20 mA
K3/7
common
K3/8
cable shield
K3/9
Ground
K3/9
Connect this pin direct to the protective ground close to the unit. Use a copper wire with
an area of 2.5 mm
5.4
K4 – HEADSET
Connect the cable from the headset (IR-HS) direct to the phono-contact in the upper part of the unit.
It is also possible to connect the cable K-HS5 between the headset and the unit
TVD-M2-M3 EN.docx
normally
open
com
K2/2
K2/3
K2/5
K2/6
K-TVDS25, K-VIMS25
white + brown
green + yellow
2
.
May 26, 2011 / BL
K1
K2
115 - 230 VAC
Mains supply
Limit 1
Limit 2
input
Relay
Relay
output
output
TVD-M2
VAL0123130
SKC9826773
TVD Touchpoint Monitor
Serial:628
dametric
K1
K2
24 VDC
Power supply
Limit 1
Limit 2
input
Relay
Relay
output
output
TVD-M3
VAL0308989
TVD Touchpoint Monitor
Serial:628
dametric
see below
TVD-M2 / TVD-M3
K3
Pro-
duction
control
Trans-
Signal
input
ducer
output
cable
4-20mA
K3
Pro-
duction
control
Trans-
Signal
input
ducer
output
cable
4-20mA
7(8)