dams Elev82 Touch EVTB-1600 Assembly Instructions Manual - Page 12
Browse online or download pdf Assembly Instructions Manual for Indoor Furnishing dams Elev82 Touch EVTB-1600. dams Elev82 Touch EVTB-1600 13 pages. Back-to-back desks
Print Page
19
Step 19
Upgrading to the Digital control unit
Make sure that your height adjustable desk is turned off and unplugged from the mains.
Unplug the controller supplied with your height adjustable desk and replace with the digital
control unit. Fix this to your top using the wood screws provided.
After connecting the digital control unit you will need to perform a reset.
Reset
• Press both up & down buttons at the same time for 3 seconds. Continue pressing the buttons
until both columns are in lowest position. When the reset is finished, the control box makes a
beep and the buttons can be released.
• When conducting reset, the display shows "000" in last 100mm stroke. When the reset hsd
finished, the display shows starting height again.
• If releasing up & down buttons before the display shows "000", the desk goes back to normal
operation.
• Reset is necessary for first operation of the desk.
Normal operation
• Press any button. 3-digits display shows current desk height in centimeters.
• Press up or down button to adjust the desk height.
• When no button has been pressed for 10 seconds, display goes off. Press any button to light
up the display again.
• When no button has been pressed for 30 seconds, the system goes to <0.1 W standby mode.
Long press any button to wake the system up. Display shows desk height again.
Memory position
The digital control unit supports 4 memory positions. to set the positions follow these steps;
1. Operate the desk to preferred height.
2. Press any of 1,2,3,4 buttons together with up or down buttons for 2 seconds to store the
current height. Display shows P1/P2/P3/P4 when the position has been stored.
3. Now, hold any of the 1,2,3 or 4 buttons until the desk reaches the stored height.
Stored postion can only be overwritten, not to be cleared.