DAN NTP TECHNOLOGY DAD Thunder Core 256 Installation Manual - Page 14

Browse online or download pdf Installation Manual for Recording Equipment DAN NTP TECHNOLOGY DAD Thunder Core 256. DAN NTP TECHNOLOGY DAD Thunder Core 256 16 pages. Thunderbolt 3, dante, madi and adat digital audio interface

Print Page
Installation Guide Core 256

Reconfig button

The "Reconfig" button on the back of the AX64 should not be used during normal installation. It is generally
intended as an ultimate recovery function in case something goes wrong during programming of IP addresses or
a software upgrade, e.g. an unintended power loss. It allows the AX64 to start in various "basic" modes so it can
be restored without having to be returned to the factory.
The "Reconfig" button is accessed via a hole in the rear panel using a pen or a similar pointed item. A green LED
is visible through the hole. When the "Reconfig" button is activated, the LED will light up indicating the two
reconfig modes of the AX64.
Reconfig mode
Doc no. AXCNTR-8001-A-4
Sync connectors
Coaxial BNC connector for Clock input synchronization, and Word
Clock output
The input clok format can be Word Clock or Video Black and Burst
(VBB)
ADAT Connectors
Two TOSLINK Inputs and two outputs. Input and output
connectors support ADAT.
S/PDIF is supported on input only.
"Reconfig
"
The AX64 enters a
pushed while the
only a basic boot software is operative in the
unit is powering
unit, and new software can be downloaded via
up
the DADman software. This mode is used if the
software in the AX64 for some reason is not
Green LED
operative or broken.
turns ON
The IP address settings of the unit are the last
setting used in the unit.
.
""Reconfig
The AX64 remains in reconfig mode as described
"
above.
short push
while the unit is in
The IP address settings of the unit is however set
reconfig mode
to DHCP. In case there is no DHCP server on the
Rev. date 201123
recovery
mode. In this mode
Page 14 of 16