DAN NTP TECHNOLOGY DAD THUNDER CORE AX64 Installation Manual - Page 9

Browse online or download pdf Installation Manual for Recording Equipment DAN NTP TECHNOLOGY DAD THUNDER CORE AX64. DAN NTP TECHNOLOGY DAD THUNDER CORE AX64 19 pages. Thunderbolt 3, dante, madi and adat modular audio interface

Print Page

Note. In order to have proper function of the AX64 the routing and sample rate configuration has to

be set correctly via DADman.

Installation of DAD Thunderbolt 3 driver for MacOS

The driver software has to be installed completely before it can work properly.

When you install the driver it is of no importance if you have units or other peripherical devices

connected to the Thunderbolt 3 / USB-C port on the computer. In the process descried below

there are no devices connected before installation.

The installation sequence is the following:

1. Copy the driver .pkg file to the computer desk top and double click in order to start installation

2. Follow the installation instructions click Next and then Install.

3. Enter Administrator password and click Install

4. If the driver has not been installed before on the computer you get the message "System extension

blocked". Click on Open Security Preferences.

5. In the "Security and Privacy" window you have to click on the lock symbol in the bottom left corner and

unlock settings and click Allow.

6. Restart the Computer and open the Thunderbolt 3 driver application, and connect the DAD

Thunder|Core interface to the USB-C/Thunderbolt 3 port on the Computer. Make sure that you are

using a high-speed (20Gbps) Thunderbolt 3 USB-C cable.

For mor information how to install and configure the Thunderbolt 3 driver please refer to the Thunder|Core

installation guide on www.digitalaudiosupport.com.

Once the driver is installed the device can be attached to via the setup window

Doc no. AX64-8001-A-4

Figure 4, DADDriver setup window

Rev. date 221023

Page 9 of 19