DAN DRYER Bjork 3222 Assembly Instructions And User's Manual - Page 3
Browse online or download pdf Assembly Instructions And User's Manual for Baby Accessories DAN DRYER Bjork 3222. DAN DRYER Bjork 3222 12 pages. Baby changing station (with safety strap)
Print Page
Reference
Version
27-10-2020
Unpacking and identification of parts:
Unpack the product with care and verify all
parts are present according to the drawings.
Tools for assembly::
• Torx key T20 (fitting the front cover)
• Electric drill
• Spirit level
Tools needed for wall-mounting will
depend on the screws and plugs
used. See the section below.
Mounting on wall:
When choosing position, remember to allow for the depth
of the table when lowered, and its height when folded up.
Refer to the dimension diagram at the end of this manual.
When choosing where to place the unit, ensure there are
no entrapment risks when folding it up or down.
Do not install the product near strong heat sources, e.g.
fireplaces, stoves, etc.
Important:
The table may only be mounted to a wall with proper inte-
rior blocking to bear the weight of the unit (18 kg) and the
maximum load of (80 kg).
Select the correct mounting fasteners for the specific
wall type. Consult an expert (e.g. your local builder's
merchants) for advice. Screws in the wall bracket are
exposed to a force equivalent to 65 kg of pull each at
maximum load on the table when 4 screws are used in
the upper holes.
We recommend to mount fasteners in all 12 holes to ob-
tain maximum strength and stability.
DAN DRYER A/S • Alsikevej 8 • DK-8920 Randers NV • www.dandryer.com • [email protected]
Document
Björk Baby Changing Station
User Manual
4 x screws for
the front cover
Warning label
Drill template
Lang.
EN-US
M4 x 10 mm
552
270
350
Recommended mount-
ing height is based on
a working height of
approx. 950 mm.
Page
3 of 12
Packaging
lid
Wall module
Front cover
Packaging for
front cover
Packaging
base