concept 2 BikeErg Replacement Manual - Page 2

Browse online or download pdf Replacement Manual for Exercise Bike concept 2 BikeErg. concept 2 BikeErg 2 pages. Frame with flywheel replacement

Print Page

BikeErg Box Frame with Flywheel Replacement

Procedure

4. Remove the six fasteners that hold the rear leg

onto the box frame. There are two fasteners on

either side and two on the top. Note that only one

side is shown in the photo. Remove the rear leg

and set it aside.

5. Remove the four fasteners that hold the front

leg onto the box frame (all four on the right side).

Remove the front leg and set it aside.

6. Install the new box frame with flywheel by

following the steps in reverse. When installing the

front leg, finger tighten all four fasteners before

tightening them fully. The same applies to the six

fasteners that secure the rear leg.

7. Using the 6 mm hex L-key re-install BOTH pedals

on the crank arms. Note that the R side pedal is

installed on the right crank arm and tightened by

turning clockwise; the L side pedal is installed

on the left side and tightened by turning counter

clockwise.

8. Remove the generator from the new box frame

and plug the monitor cable into it. Ensure that both

cables are routed through the retention loops and

out the corner reliefs, then reinstall the generator.

9. Recalibrate the BikeErg by following the

instructions on the PM5.

Left Side

Page 2

0119