Dan's Comp Front Load Stem Installation Manual - Page 4
Browse online or download pdf Installation Manual for Bicycle Accessories Dan's Comp Front Load Stem. Dan's Comp Front Load Stem 5 pages.
Print PageInstalling the Handlebars
•
Loosen and remove the clamping bolts holding the face plate
on the top or front of the stem.
•
Place the face plate back on and start threading the bolts into
the stem body.
•
Tighten the stem clamp bolts in a cross pattern. Be careful not
to over tighten the bolts, as you can crush the bars or strip the
threads in the stem. Loose stem bolts can also strip the bars
clamp area.
•
As you are tightening the bolts, the gap between the face plate
and stem body needs to be the same all of the way around.
These instructions are to be used as a guide only. Improperly installed parts may lead to severe injury or harm. We strongly recommend that
a properly trained bike mechanic handle all installations, adjustments and repairs on your bike. As always...Ride Safe!
AMain.com Inc.
Front Load Stem Installation
•
Apply a little grease to the threads of the bolts before threading
them back into the stem.
•
Place the handlebars in the stem
•
Use the knurling (the rough area) on the handlebars to help
center them in the stem.
1-844-970-4269
www.danscomp.com
Page 4