Anybus X-gateway Installation Sheet

Browse online or download pdf Installation Sheet for Recording Equipment Anybus X-gateway. Anybus X-gateway 2 pages. Profibus master interface
Also for Anybus X-gateway: User Manual (20 pages), Network Manual (14 pages), Network Manual (16 pages)

Print Page
Anybus X-gateway
Concept
The Anybus X-gateway acts as a translation device between two
different fi eldbus networks.
Network 1
24 VDC
Network 2
Internally the gateway consists of two separate network interfaces,
mounted at the top and bottom end of the gateway respectively, and a
translation device handling communication between the interfaces.
For more information about the specifi c interfaces, please refer to the
Network Installation Sheet for each fi eldbus network.

Top view

Power Connector (X3)
See Network Installation Sheet
for connector details

Bottom view

See Network Installation Sheet
for connector details
SP1747, rev. 2.10, Oct 2015

Front view

USB
Gateway Status LED
Indication
Green
Red
Red (fl ashing)
The interface-specifi c LED indicators are described in the Network
Installation Sheets for the respective fi eldbus network interfaces.
Power Connector (X3)
Top-mounted interface
GW Status
Gateway Status LED
2–4 interface-specific LED Indicators
(see Network Installation Sheet)
Bottom-mounted interface
GW Status
Gateway Status LED
2–4 interface-specific LED Indicators
(see Network Installation Sheet)
USB Connector (X4)
Meaning
Communication running
Communication error
Network interface error
Pin
Signal
+
24 VDC ±20 % Class 2
–
Ground
Gateway Installation Sheet
DIN Rail Mounting (standard)
Align the gateway with the DIN rail connector, then press fi rmly on the
top end and push the lower end into place.
To dismount the gateway, press fi rmly on the top end, then pull the
lower end away from the DIN rail.
Mount
1
2
DIN Rail Mounting (sideways)
Remove the sticker covering the screw holes on the right side panel.
Unscrew the DIN clip from the back and refi t it to the side panel.
Mount/dismount the gateway the same way as in standard mounting.
Screw holes behind sticker
Remove for optional DIN refitting
T10
Technical Specifi cations
Power supply
24 VDC ±20 % Class 2
Power consumption
200 mA at 24 VDC (typical)
400 mA at 24 VDC (maximum)
Operating temperature
-25 to +65 °C @ 400 mA/24 VDC
Non-operating temperature
-40 to +85 °C
Relative humidity
5–95 % non-condensing
Protective Earth (PE)
Internal connection to PE via the DIN rail

Technical Support

Technical support, documentation and software downloads are
available at www.anybus.com.
Dismount
1
2
www.anybus.com