Concoa 522 Series Installation And Operation Instructions Manual - Page 7

Browse online or download pdf Installation And Operation Instructions Manual for Controller Concoa 522 Series. Concoa 522 Series 17 pages. Autoswitch monitoring system
Also for Concoa 522 Series: Installation And Operation Instructions Manual (20 pages)

Print Page

1. Installation

WALL MOUNTING

Follow Compressed Gas Association, OSHA and all applicable local codes. Manifolds should not be

placed in locations where the temperature will exceed 102°F (49°C) or fall below 0°F (-18°C). Manifolds

installed in open locations should be protected from weather conditions. During winter, protect the

manifold from ice and snow. In summer, shade the manifold and cylinders from continuous exposure

to direct sunlight. Always leave access to the manifold for cylinder replacement.

1. Determine and mark the vertical center line for installation of the AutoSwitch Console.

(Figure 3).

2. Measure from the floor 73" in height* of this center line. This height will place the manifold

header approximately 66" from the floor. Using a level, mark a horizontal line at this point

extending approximately 10 inches to the left and right of center.

3. Remove the mounting bracket from the rear of the AutoSwitch Console by removing the

retaining nuts at the bottom of the mounting bracket (Figure 5). Place the upper edge of

the bracket cross-member on the horizontal line so that it is centered with the vertical line.

Holding the bracket with the slotted extensions away from the wall, mark the location of the

two mounting bolts (Figure 4)

4. Using appropriate hardware based on wall construction, anchor the mounting bracket to the

wall (Figure 4).

5. Place the autoswitch system so that the mounting bracket slots align with the shoulder nuts.

With the autoswitch box hanging on the shoulder nuts, align the retaining bolts so that they

protrude through the bracket. Replace the mounting nuts that were removed in step 3.

Figure 3 - Center-line Mark

Console

Figure 5 - Console and Mounting Bracket

Mounting Screws

Figure 4 - Mounting Bracket

Shoulder Nuts

Mounting Bracket

Retaining nuts