Duct-O-Wire CAS-2L100 DUPLEX Installation And Operating Instructions

Browse online or download pdf Installation And Operating Instructions for Accessories Duct-O-Wire CAS-2L100 DUPLEX. Duct-O-Wire CAS-2L100 DUPLEX 3 pages. Bi-directional laser collision avoidance kit

Print Page

 This product incorporates IR Laser Protection Class 2; visible laser light.

 Do Not Stare Into The Laser Beam!

 C1,C2 Relay coils are 120VAC rated.

 The Q1,Q2,Q3,Q4 coils are controlled by a 24 VDC laser.

 This unit may not be suitable for all applications.



Before installation you will need a qualified technician to verify this unit will work with your

application.

The Duct-O-Wire® CAS-2L100 DUPLEX Two Event Laser Collision Avoidance Kit comes with (2) Laser Sensor Units,

(2) Sensor Mounting Brackets and Hardware, (2) 10 Meter Data Cables, (1) DIN Mounted Power/Relay Module,

(2) Reflector Arrays with Mounting Hardware, Schematic Sheets and Warning Labels.

Laser Class2 Max Power 4.1 mW Time Base 100 s Pulse Duration 1.3 ms

Wave Length 650 mm Compliance: 21 CRF PART 1040 ENC60825-1:2003-10

MAKE CERTAIN THAT THE POWER SUPPLY IS DISCONNECTED BEFORE INSTALLING, REPAIRING, OR MAKING

ADJUSTMENTS TO THIS DEVICE. THIS DEVICE IS TO BE INSTALLED BY QUALIFIED ELECTRICAL PERSONNEL ONLY.

MOUNTING AND ALIGNMENT

1. Mount sensor and reflector using supplied bracket and hardware to suitable locations for stability and

proper alignment. Use 3 point alignment method to ensure the laser and reflector are in a straight line,

both horizontally and vertically true.

2. Connect the supplied data cable to the sensor and power/relay module per the drawing.

3. Attach the supplied Laser Warning Label in the immediate vicinity of the sensor unit.

4. Connect 110 VAC to the transformer per the schematic drawing.

5. A visible red light will be seen from the sensor to the reflector. Do Not Stare Into the Laser Light.

SENSOR PROGRAMMING-FEET MODE (

NOTE: ALL BUTTON PRESSES MST BE DONE WITHIN 15 SECONDS

1. Press and release the Mode/Enter button until EF is displayed. (multiple presses)

2. Press and release the SET button.

3. Press and release the Mode/Enter button until Uni is displayed. (6 button presses)

4. Press and hold the SET button until FEET is displayed, and release.

5. Press and release the Mode/Enter button once to confirm.

6. Wait 15-20 seconds and the unit will return to the "run" mode.

7. When sensor is in Run mode, distance to target is displayed in feet.

SENSOR PROGRAMMING-SET POINT 1

NOTE: If the desired distance is passed, the counter will need to be advanced until the set point is displayed

again. ALL BUTTON PRESSES MUST BE DONE WITHIN 15 SECONDS.

1. Press and release the Mode/Enter button until SP 1 is displayed. (2 presses)

2. Press and hold the SET button until the desired distance for the first event is displayed, then release.

3. NOTE: Minimum distance is 1 meter (3.28 feet).

4. Press and release the Mode/Enter button once to confirm. The display will show SP 1.

Duct-O-Wire®

CAS-2L100 DUPLEX

BI-DIRECTIONAL LASER COLLISION AVOIDANCE KIT

INSTALLATION AND OPERATING INSTRUCTIONS

Use a pen or small blunt object for improved response

First Event Distance Q1 and Q3

(

)