Concoa 529 5134-01-230 Installation And Operation Instructions For - Page 4

Browse online or download pdf Installation And Operation Instructions For for Security System Concoa 529 5134-01-230. Concoa 529 5134-01-230 4 pages. Protocol station remote alarm

Print Page

Figure 1. Connector Assembly

Press the silence button to turn off the buzzer.

10. Check the function of the alarm system by pressurizing the system and allowing the system to depres-

surize. When the cylinder is low (below the set point on the gauge), the green LED should turn off and

the red LED will illuminate. The buzzer will also sound. The buzzer may be silenced by pressing the

remote alarm's silence button.

OPERATION

The alarm is used to provide an audible and visual warning that a cylinder is nearly depleted.

alarm set point does not affect the operation of the system. No adjustment of the alarm set point during

normal operation should be necessary. If adjustment of the alarm set point is required, slide the red tab seen on

the inlet gauge to the desired alarm point (see figure 2).

If the green remote alarm LED's do not illuminate when the transformer is plugged in and the remote alarm is

not connected to the switchover, check the fuse. Disconnect the transformer from the power source. Remove

the four screws on the rear of the remote alarm. Remove the rear panel. Replace the fuse with the one indicated

on the label. Replace the rear cover and screws. Plug in the wall transformer. Check the remote alarm.

Adjusting the

Electrical Connection

Behind Pigtail

Alarm Set Point

Figure 2. Electrical connector and alarm setpoint location

Pressure Switch

Gauge

Electrical Connector