Concoa 632 Series Installation And Operation Instructions Manual - Page 6
Browse online or download pdf Installation And Operation Instructions Manual for Industrial Equipment Concoa 632 Series. Concoa 632 Series 17 pages. Gas distribution system
Print Pagethe typical installation for high-pressure cylinders needs 66 inches between the floor and the "INLET" port.
Leave enough space between the cylinder tops and the manifold.
3. Place the upper edge of the panel on the horizontal line so that the 6700 Series delivery regulator is centered
with the vertical line.
Figure 3
4. As illustrated in Figure 3, the 63 is secured to a panel that has mounting holes located at each corner.
5. Mark the location of the panel mounting holes.
6. Using the appropriate hardware, anchor the switchover mounting bracket to the wall. Make sure the panel
is level.
7. Tape the ¼" M-NPT thread of the cylinder pigtail.
8. Secure the street elbow with a wrench while threading the taped male NPT end of the pigtail.
9. Repeat steps 7-8 for the opposite inlet of the switchover.
10. Refer to "Connecting a Cylinder" for directions on connecting the pigtail to the cylinder.
11. Refer to "Pressure Testing the System" to confirm that there are no leaks in the system.
632 Installation with Single Hose with Master Valve
This configuration does not include an inlet pressure gauge.
1. Determine and mark the vertical line of center for installation of the 63 system.
. Measure from the floor 73" and make a mark on the line of center. Using a level, draw a horizontal line
from the mark extending approximately 10 inches to the left and right of center as illustrated in Figure .
The height of 73 inches is recommended; the typical installation for high-pressure cylinders needs 66 inches
between the floor and the "Inlet" port. Leave enough space between the cylinder tops and the manifold.
3. Place the upper edge of the panel on the horizontal line so that the 6700 series delivery regulator is centered
with the vertical line.
4. As illustrated in Figure 3, the 63 is secured to a panel that has mounting holes located at each corner.
5. Mark the location of the panel mounting holes.
6. Using appropriate hardware, anchor the switchover mounting bracket to the wall. Make sure the panel is
level.
7. Tape the ¼" M-NPT thread of the cylinder pigtail.
8. Secure the street elbow located on the master valve with a wrench while threading the taped male NPT end
of the pigtail as illustrated in Figure 4.
9. Repeat steps 6 through 7 for the opposite inlet of the switchover.
-6-