AnyTone AT-5289 User Manual - Page 7
Browse online or download pdf User Manual for Radio AnyTone AT-5289. AnyTone AT-5289 13 pages.
Print Page
HOW TO USE YOUR RADIO
Manual Squelch
11
Turn the SQUELCH knob clockwise to the exact point where all
background noise disappears. Please note that this control is fine
regulation, if you set it to the maximum (fully clockwise), the radio can
only receive the strongest signal.
Volume switch
21
a) To turn the radio on, turn the VOLUME knob clockwise.
b) To increase the sound level, turn the knob further clockwise.
FUN key
31
a) Choose band
Press and hold it for over 2 seconds to enter band selection, turn the
channel knob to choose a band, press FUN again to exit, the radio
will work on selected band.
The frequency and channel information in band A to band L, VFO (1
channel), MEM (8 channels) total 12 bands can be programmed by
4
software. The frequency in band E, UK, PL can not be programmed,
but the channel information can be changed by software.
Factory Defaulted with only E, UK band, add other bands by software
if need.
b) Combined Functions
Press FUN, the LCD display "FUNC", when "FUNC" disappear, press
ASQ, TST, SC, A/F, MEM, DW, PRG key to enter the function printed
below the buttons.
ASQ key
41
a) ASQ: Press ASQ, The LCD displays "ASQ", the ASQ function is
on; press it again to turn off ASQ.
Note: ASQ will automatically turn off if the TSQ function turned on.
b)BEP: Press FUN, the LCD display "FUNC", when "FUNC"
disappear, press ASQ, the LCD displays "BP", the key beep function
is on, press it again to turn off BEP function.
TSQ key
51
a) TSQ: CTCSS and DCS code
Press TSQ, The LCD will display "CTC or DCS", the CTCSS or DCS
function is on; press it again to turn off the function.
Note1: This function is available only when you installed optional CTC board.
Note2: when you choose RXC or TXC off, this function is not valid.
Note3: When the CTCSS or DCS is on, the speaker will boot only when it
receive corresponding CTCSS or DCS code.
Note4: When the CTCSS or DCS is on, the RB function will turn off.
b)TOT (Timer Out Timer)
Press FUN, the LCD displays "FUNC", when "FUNC" disappear, press
TSQ, the LCD displays "XXX S", you can adjust the TX limit time by
the channel knob, press any other key to exit, or wait for 5 seconds , the
radio will store the setup and exit.
When the continuous TX time is over the TOT limit, the radio will stop TX.
TOT Optional: 15-600 seconds, step 15seconds, default: 180Seconds
SC key
61
SC (Scan function)
Press SC, The LCD displays "SC" and flashes, the radio start scan
function, turn the channel knob to select the scan mode, press any key
to exit scan.
Note: the scan only on pre-stored channels in present BAND or MEM.
SKP (Scan Skip function)
Press FUNC, the LCD display "FUNC", when "FUNC" disappear, press
SC, the present channel will delete from the scan list. The scan will skip
this channel. Press the key again to add present channel to scan list.
A/F key
71
A/F (AM/FM switch)
Press it to switch between AM and FM mode, the LCD will display AM
or FM.
HI (High low power function)