Dudley Resan Fitting Instructions - Page 2

Browse online or download pdf Fitting Instructions for Toilets Dudley Resan. Dudley Resan 4 pages. Vandal resistant wc pan

Print Page

Warning

60kg heavy product. It is recommended that at least two people carry out the installation to

prevent personal injury or any damage to the pan.

Important

Please read these instructions carefully before installation.

Disclaimer

1. The specifications of this product can change without notice as a result of continual product

development.

2. These instructions are intended to be a general guide only as specific conditions vary from

installation to installation.

3. The images in these instructions are for illustrative purposes only and may vary slightly from

the actual product as a result of continual product development.

4. Check the product for defects or damage prior to fitting. Fitting the product is an acceptance

that the product is free from defects and Thomas Dudley Limited cannot retrospectively

accept responsibility for any defects subsequently discovered.

Component Checklist

1. WC Pan

2. 4 x M10 threaded fixing studs

3. 4 x M10 lock nuts

4. 4 x M10 washers

5. Paper drilling template

6. Instruction leaflet

7. 5 x Restrictor Rings. 24, 26, 28, 30 & 32mm Options.

Equipment Checklist: Not Supplied

1. Drill, masonry bits and hole saw (optional) suitable to create required holes

2. Adjustable Spanner

3. Spirit level

4. Pencil

Unpacking

1. Unpack the pan taking care to avoid scratching or otherwise damaging the surface finish.

2. Check for any defects.

Pan Preparation

1. Fit a straight 4" waste pipe connector onto the waste spigot with a pipe long enough to pass

through the wall and connect to the waste system.

2. Insert the flush pipe connector corresponding to the size of flush pipe to be used. For best

performance always use a full length flush pipe if possible. If necessary fit one of the five

Restrictor Rings between the flush pipe and the WC depending on the flow rate on site. A

higher flow rate will require a smaller restrictor to minimise any splashing. (See Positioning

the Cistern).

3. Hand tighten the 4 off M10 threaded fixing studs into the threaded inserts on the back of the

pan. If the supplied rods are not long enough to pass through the wall it will be necessary to

cut lengths of standard M10 all-thread down to the correct size.

12019 iss1 R325609

2 of 4