Anywire AnyWireASLINK BL296PB-16F-4A-20 Product Manual - Page 3

Browse online or download pdf Product Manual for Touch terminals Anywire AnyWireASLINK BL296PB-16F-4A-20. Anywire AnyWireASLINK BL296PB-16F-4A-20 17 pages.

Print Page

[About Single Unit Simpliﬁed Replacement]

During replacement of a slave unit, this function enables automatic settings of address and parameters of the existing

slave unit into a new slave unit. (After replacement of the slave unit, address and parameter setting procedure using the

address writer is not required.)

■Step 1 Turn OFF the 24V DC power supply for the master unit.

■Step 2 Disconnect a slave unit to be replaced.

ASLINK

master unit

■Step 3 Connect a new slave unit.

ASLINK

master unit

■Step 4 　Turn ON the 24V DC power supply to the master unit.

- It is necessary that both the master unit and slave unit should be compatible with the single unit simpli ed replacement function.

CAUTION

- Before disconnection and connection of the slave unit, be sure to turn OFF the power supply.

- For compatibility of a slave unit with the single unit simpli ed replacement function, see the lot No. and the manual for the slave unit.

- When a slave unit of a new function version is replaced with that of an old function version, the single unit simpli ed replacement

function cannot be used.

- Operation is enabled in the case where the model of the slave unit before replacement is the same as that after replacement.

- If the model of the slave unit before replacement is different from that after replacement, a model mismatching error occurs, disabling

address and parameter settings.

- Operation is enabled in the case where the address of the slave unit for replacement is the factory-set address (bit address 511).

- Several slave units cannot be simultaneously replaced. For replacement of several slave units, conduct the replacement procedure for

each unit one by one.

- For a slave unit incompatible with the single unit simpli ed replacement function, set an address and parameters by using the address

writer as in the conventional manner.

- For details of the single unit simpli ed replacement function (limitations, conditions, etc.), refer to the manual for the master unit.

■Identi cation of function version

Function version information is given on the lot label.

The design and contents of the lot label may vary depending on the product model and lot No.

NEW

Function version:

When an equipment parameter is changed due to functional upgrading, etc., the function

version will be updated (for example: A→B→C).

When a slave unit of a new function version is replaced with that of an old function version,

the single unit simpli ed replacement function cannot be used.

-BL296*B16F*4A20 3/17-