Danby DDW1802 Service Manual - Page 11

Browse online or download pdf Service Manual for Dishwasher Danby DDW1802. Danby DDW1802 12 pages. Dishwasher division 22 461
Also for Danby DDW1802: Service Manual (16 pages), Service Manual (15 pages)

Print Page
Danby DDW1802 Service Manual
Repeated
dishwasher
cycles
eTimer (contacts open or burnt)
rMotor
(inoperative,
check
resistances).
Replace timer.
Replace timer.
Timer does not advance
automatically.
.Timer motor (stalled or open).
rCheck timer for power to timer
motor.
oTimer shaft binding or knob
interference to escutcheon.
Replace timer.
Replace timer.
Repair or adjust.
Dishwasher will not fill
with water.
oWater supply turns off.
rDefective inlet valve.
rCheck
valve
screen
for
obstructions.
rDefective fl oat switch.
rTimer contacB (open or burnt).
eWirinq (broken or burntl.
Turn water supply on.
Replace inlet valve.
Disassemble and clean screen.
Replace switch.
Replace timer.
Repair or replace.
lncomplete water fill.
oLow water pressure.
oClogged water inlet
valve
screen.
rTimer advanced past start of fill
cycle.
.Heavy
water supply
usage
elsewhere in home,
rKinked or restricted fill hose,
water inlet valve to fill tunnel.
Minimum water pressure of
1sP.S.r
Clean water inlet valve screen.
Instruct customer/user to turn
timer dial to start indicator
mark.
Use dishwasher when water
usage is at a minimum.
Correct as needed.
Too much water fill.
.Water inlet fill valve defective.
oTimer contacB (open or burnt).
.Float arm binding or out of
adjustment.
oPossibility customer/user tumed
timer past drain cycle.
Replace water inlet fill valve.
Replace timer.
Repair, adjust or replace.
Instruct customer/user.
Dishwasher will not pump
out.
oDrain pump is restricted.
oDamaged impeller.
oWiring or terminal (contacts
open or burnt).
Clear restrictions.
Replace drain pump.
Replace timer.
Water siphons out.
.Drain hose loop to low.
oDrain line connected to a floor
drain not vented.
Move to proper height.
Install vent air gap at counter
top.
Water leaks.
.Spray arm not rotating or split.
O Overcharge of water.
oTub seal (torn, worn or loose).
oDishwasher door not sealing
properly.
oDishwasher is not level_
oOverburden (wrong type of
detergent).
oHose clamps loose.
.Heater element mounting nuts
loose.
oWater seal leaking.
oO-ring is not in position.
oMotor and pump assembly not
seated proper in tub liner bottom.
Check for proper rotation or
replace spray arm.
Check and correct for proper
fill.
Replace tub seal.
Adjust door latch assembly
and/or strike.
Level dishwasher properly.
Instructs customer/user.
Tighten all clamps securely.
Tighten the nut.
Use a new water seal.
Adjust the ring or replace a
new.
Replace seal.
Poor wash ability.
.Spray arm not rotating.
olmproper loading of dishes,
pans and other.
.Detergent dispenser inoperative.
rlnsufficient amount of detergent.
Orthe detergent is old.
rDamaged or the impeller is
broken.
.Detergent not dissolve.
Check for proper rotation.
Instructs customer/user on
proper loading
per owner's
guide.
Repair or replace dispenser.
On proper amount of fresh
deter gent to use.
Replace pump assembly.
Incoming water temperature of
140"F is required to proper
dissolve deteroent.