Dancing Wings Hobby E30 Instruction Manual - Page 2

Browse online or download pdf Instruction Manual for Toy Dancing Wings Hobby E30. Dancing Wings Hobby E30 4 pages. Micro rc foamy biplane

Print Page

KIT

配件图仅做参考用，您收到的实物可能因为修改/优化的原因导致与图片有略有不同。

Photos shown here just for reference, the product you received maybe slightly differ from the photos due to

continuous improvement on products.

机身拼装 Assemble the Fuselage

01-1

01-2

01-3

A1-2：机身 Fuselage

B1-2：机翼 Wing

B3：水平尾翼 Horizontal Tail

C：机翼支架 Wing Structs

D1-2：起落架，轮子

Landing Gear; Wheels

E1-3：碳片 Carbon sheet

F：碳杆 Carbon Rod

G1：连杆连接件

Linkage connector

G2：舵角 Servo Horn

H1-2：钢丝连杆

Steel Wire Linkage

I：马达座 Motor mount

J：热缩管

Heat-shrinkable Tube

在两片A1的反面均匀涂抹泡沫胶。

在A2的两侧均匀涂抹泡沫胶。

Spread foam glue evenly on the

reverse sides of the two pieces of

A1.

Spread foam glue evenly on

both sides of A2.

把涂好胶水的A1粘到A2的两侧，粘

贴时对齐边缘及各对应的空位。

Paste the glued A1 to both sides

of A2, and align the edges and

corresponding spaces when

pasting.

把转向舵从机身切下，用模型刀切割转向舵与机身连接处，

切出45度斜面。

Cut the steering rudder from the fuselage, use a model

knife to cut the connection between the steering

rudder and the fuselage, and cut a 45-degree slope.

机翼拼装 Assemble the Wing

02-1

在下机翼B2底面预留槽内嵌入E1碳片，并用泡沫胶把碳片粘固在槽内。

Insert the E1 carbon sheet into the reserved groove on the bottom of the lower wing

B2, and fix the carbon sheet in the groove with foam glue.

把舵机通电回中，并安装

02-2

一字型舵臂。然后切掉舵

机支架。

Power on the servo

back to the center, and

install a flat servo arm.

Then cut off the servo

bracket.

02-4

把下机翼穿入机身下端预留槽内，调整居中并调整好舵机位置，然后用泡沫胶涂抹连接处粘固。

Insert the lower wing into the reserved groove at the lower end of the fuselage, adjust

the center and adjust the position of the servo, and then apply foam glue to the

connection to fix it.

02-5

把02-1步骤粘好的机

02-3

翼翻转，装入舵机并把

舵机线放置到正面。(

如左图安装)此处舵机

不要粘。

Turn over the wing

glued in step 02-1,

install the servo and

place the servo line

to the front. (as

shown on the left)

Do not paste the

servo here.