Anzzi L-AZ021 Installation Manual - Page 2

Browse online or download pdf Installation Manual for Kitchen & Bath Fixtures Anzzi L-AZ021. Anzzi L-AZ021 2 pages. Single handle lavatory faucet

Print Page

Step 1

Faucet installation

HOT

COLD

1.Assemble the 2 flexible hose to the faucet by hand.

2.Put the faucet into the installation hole of the basin. Make sure o-ring be on the base of faucet. Assemble screw #23

to the base of faucet, and assemble rubber washer #21 and clamp #22 to screw #23. Then assemble lock nut #24 by

basin wrench to screw #23 to fix the faucet.

HOT

COLD

3.Connect the

flexible hose

to water supply valve (not included), and tighten it with adjustable wrench.

DON'T OVER TIGHTEN!

Caution: make sure connect the hot and cold flexible hoses to supply valves correctly.

Warning:

The supply valves are not included, please purchase them in plumb shop.

O-ring

Pop-up installation

flange

top rubber washer

drain stopper

drain body

o-ring

sink base

flange

sink

washer

bottom

rubber

drain body

locknut

washer

align hole in

drain stopper

with guide rod

opening

(pointed toward

tailpiece

back wall)

1.Remove pop-up drain stopper, and flange with top rubber washer for pop-up assembly. Insert drain body from

underneath of sink drain hole. Replace flange and top rubber washer back to drain body. Tighten flange as far as

possible. Remove and put silicone along bottom of. (Optional) Slide bottom rubber washer on drain body up against

bottom of sink. Tighten washer and locknut firmly against base for tight seal. Remove tailpiece from drain body, add

Teflon tape, replace tailpiece.

2.Replace pop-up drain stopper to drain body with o-ring in place, and align stopper hole with guide rod opening.

3.Remove rod guide nut and rod ball plastic gasket. Insert horizontal rod into drain body and through hole in drain

stopper. Replace rod guide nut with rod ball plastic gasket and tighten it.

4.Insert lift rod through hole on faucet body. Connect extend rod to lift rod. Attach horizontal rod to extend rod using

fittings, tighten screw.

Step 2

Checking and testing

1.Remove the aerator by

hand

. Turn the faucet handle all the way on, turn on hot and cold water supply and flush

water lines for one minute. Reinstall aerator by hand.

2.Check all connections at arrows for leaks, re-tighten it if necessary. BUT DON'T OVERTIGHTEN!

lift rod

faucet

body

horizontal rod

drain body

drain

stopper

extend rod

screw

hole

rod ball

rod guide nut

plastic

gasket

horizontal rod

fittings