Dancover 5.4m Series Manual - Page 6

Browse online or download pdf Manual for Tent Dancover 5.4m Series. Dancover 5.4m Series 7 pages. Garage tent
Also for Dancover 5.4m Series: Manual (6 pages)

Print Page

3. On each end of (no. 3), install the Leg (no. 1). Repeat step 1 for all frames.

4. At this point stand up the front or back frame and add 7 male connecting pipes (no. 8). Then stand up

another frame and add 7 female connecting pipes (no. 2). For the remaining frames use the male

connecting pipes (no. 8).

5. Add the diagonals (no. 9) to the rst and last legs (no. 1).

Note: Make sure all screws are tight. Do not over-tighten.

6. ROOF ASSEMBLY

Take the roof and place it over the structure. Make sure

that the windows are on the two sides of the shelter, at

front or at back as your choice.

Tie all the ropes around the pipes.

7. SHELTER REINFORCEMENT

Before you install the oor brackets, make sure the

distance between the legs is 18 feet wide.

Place the oor brackets (14) at each end of the shelter.

Then drive in nails (15) into ground, gravel or asphalt.

Other material surfaces require other types of anchoring

(cement blocks, sand bags, screw and bolt, etc). Permanent

anchors are not provided with this unit.

8. DOOR INSTALLATION

Install doors at each end. Connect door with roof by velcro

as shown. Use elastics (13) to attach the door to the roof

with hooks (11). Close the end of hook on the elastic so it

won't fall on out. Use the rail hooks to attach door the door

rails. When closing at the front, make sure all elastics are

attached on the inside and outside of the shelters.