3onedata RACK2100-F-2AC Quick Installation Manual - Page 4

Browse online or download pdf Quick Installation Manual for Racks & Stands 3onedata RACK2100-F-2AC. 3onedata RACK2100-F-2AC 5 pages. Industrial multi-service rack

Print Page
DIP
ON Status
OFF Status
(remote offline alarm)
Note:
Only 1 fiber port + 1 copper
port Gigabit device supports
LFP.
Enable flow control
Disable
2
function
function
Managed daughter
card:Device is in
remote mode. STA
indicator would blink
3
when device is in
remote mode.
Unmanaged daughter
card: reserved
Gigabit daughter card:
enable specified 100M
4
100M daughter card:
reserved

【Console Port Connection】

The device provides 1 channel procedure debugging port
based on RS-232 serial port. The interface adopts RJ45 port.
The pin definition as follows:
PIN
2
3
PIN
TXD
RXD
definition
【Checking LED Indicator】
The device provides LED indicators (this indicator includes
rack, management card and daughter card indicator) to
monitor the device working status with a comprehensive
simplified troubleshooting; the function of each LED is
described in the table as below:
Type
Indicate
LED
Description
disable LFP (remote
Rack
offline alarm)
Indicator
flow
control
Managed daughter
card:Device is in
local mode. STA
indicator is on when
device is in local
mode.
Unmanaged
Managem
daughter card:
ent card
reserved
Indicator
Gigabit daughter
card: disable
specified 100M
100M daughter card:
reserved
5.
GND
Daughter
card
Indicator
ON
PWR is connected
normally
P1/P2
OFF
Power supply is
connected abnormally
or not connected.
Blinking
The device is running
normally if the indicator
is blinking at a
frequency
RUN
ON/OFF
The device is running
abnormally or is being
powered on
ON
The port is normally
connected
Blinking
The port exists data
UP/DO
transmission
WN
OFF
The port is
disconnected or running
abnormally
ON
The port is normally
connected
CONS
OFF
The port is
OLE
disconnected or running
abnormally
Interface has
ON
established valid
LINK
network connection
(GS1-
Interface is in network
GS2/G
Blinking
active status
1-G2/
Interface hasn't
GF)
OFF
established valid
network connection
TP
OFF
Copper port is not
connected
Blinking
The copper port exists
data transmission
ON
Copper port connection
indicator
OFF
Fiber port is not
connected
FX
Blinking
The fiber port exists
data transmission
ON
Fiber port connection
Blinking
The daughter card is
running normally and in
remote mode.
OFF
The daughter card is
STA
not powered on/system
failure
ON
The daughter card is
running normally and in
local mode.
OFF
LFP function is not
enabled or port is
connected normally
LFP
ON
LFP function is enabled,
port is connected
abnormally
Note:
LFP function means that after LFP function is enabled
through the DIP switch, when any port of the daughter
card panel is disconnected, the LFP alarm indicator will
be on and the connection of another port will be forcibly
disconnected.
【Logging in to WEB Interface】