cascade corporation F Series User Manual - Page 8

Browse online or download pdf User Manual for Forklifts cascade corporation F Series. cascade corporation F Series 20 pages. Double/triple sideshifter

Print Page

TRUCK REQUIREMENTS

Truck Relief Setting
2250 psi (155 bar)
3500 psi (240 bar)
Truck Flow Volume
Min.
1 GPM
F-SSD
(4 L/min.)
F-SST
➀ Cascade F-Series Sideshifters are compatible with SAE 10W
petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-5606 or
MIL-0-2104B. Use of synthetic or aqueous base hydraulic fluid
is not recommended. If fire resistant hydraulic fluid is required,
special seals must be used. Contact Cascade.
➁ Flow less than recommended will result in a slow sideshift speed.
➂ Flow greater than maximum can result in excessive heating,
reduced system performance and short hydraulic system life.
Carriage Mount Dimension (A) ITA (ISO)
A
Class II
Class III
GA0028.eps

HYDRAULIC SUPPLY

Double Sideshifter (SSD)
The Double Sideshifter will require one of the hydraulic
supply arrangements shown below. All hoses and fittings
should be at least No. 6 with 9/32 in. (7 mm) minimum ID.
Refer to Cascade Hose & Cable Reel Selection Guide, Part
No. 212199 to select the correct hose reel for the mast and
truck.
INDEPENDENT SIDESHIFTING
(Requires two truck auxiliary valves or solenoid)
A and B
SIMULTANEOUS LEFT/RIGHT SIDESHIFTING
(One truck auxiliary valve)
A or B
SIMULTANEOUS OPEN/CLOSE SIDESHIFTING
(One truck auxiliary valve)
A or B
OPEN/CLOSE SIDESHIFTING and
LEFT/RIGHT SIDESHIFTING (Valve equipped)
(Requires two truck auxiliary valves or solenoid)
A and B
7
Recommended
Maximum
➀
Recommended
➁
2 GPM
(8 L/min.)
Minimum
14.94 in. (380.0 mm)
15.00 in. (381.0 mm)
18.68 in. (474.5 mm)
18.74 in. (476.0 mm)
Max.
➂
3 GPM
(12 L/min.)
Maximum
Carriage –
bars. Make sure that bars are parallel and
ends are flush. Grind smooth any protruding
welds that may affect sideshifter lower
bearings. Repair any damaged notches.
A
A
RH THINLINE 2-Port Hose Reel Supply Group
B
Mast Single Internal Hose Reeving
GA0095.eps
Clean and inspect carriage
B
GA0026.eps
6888419-R1