cascade corporation J Series User Manual - Page 12

Browse online or download pdf User Manual for Power Tool cascade corporation J Series. cascade corporation J Series 18 pages.

Print Page

NSTALLATION

Install Forks

Use pallets or blocks as necessary to

raise forks to installation height. Keep feet

clear of forks when installing.

If equipped, remove backrest. For

reassembly, tighten Cascade backrests

to 145 ft.-lbs. (195 Nm). For other

backrests, see OEM recommendations.

If equipped, remove fork shaft retainer

capscrews. For reassembly, tighten

capscrews to 50 ft.-lbs. (65 Nm).

Pull the fork shaft out of the attachment

enough to install fork into fork carrier.

Slide the fork shaft through the fork

carrier and fork.

Check fork shaft and lower

frame bar lubrication

The fork shaft and lower frame bar is

prelubed at the factory with grease. No

additional lubrication is required during

installation.

NOTE: After 300 hours of operation, the

fork shaft and lower frame bar should be

checked for contamination. If there is

contamination, clean fork shaft and lower

frame bar. Apply chassis grease to the fork

shaft and apply chassis grease or Slip-Plate

(or equivalent 'paint-on' graphite) to the

lower frame bar.

FP1144.eps

Fork Shaft

FP1183.eps

Front View

(Sideshifting Fork Positioner shown)

Fork Shaft Retainer

Backrest

Lower Frame Bar

6082563-R2 EN