Abtus MU-CATHD11T/2-06-ST Manual

Browse online or download pdf Manual for Extender Abtus MU-CATHD11T/2-06-ST. Abtus MU-CATHD11T/2-06-ST 2 pages. Hdmi over cat-5 wall plate extender

Print Page

SPECIFICATION

MU-CATHD11T/2-06-ST

1×HDMI

Input:

2×RJ45 + 1x 3.5mm

Output:

Controllable via IR pass-through from RX to TX

HDMI Source Control:

Electro-optical characteristics: τ = 25º /

IR Remote Control:

20~60kHz

Carrier frequency:

Type A (19-pin female)

HDMI Connector:

WE/SS 8P8C

RJ45 Connector:

3.5mm jack for IR emitter

3.5MM Connector:

None EQ for signal equalization

ROTARY CONTROL:

HDMI Deep Color

HDMI COMPLIANCE:

Yes

HDCP COMPLIANCE:

Single-link 225MHz (6.75Gbps)

VIDEO BANDWIDTH:

480i / 480p / 720p / 1080i / 1080p60 24/30/36-bit color

VIDEO SUPPORT:

Surround sound (up to 7.1ch) or stereo digital audio

AUDIO SUPPORT:

HDMI over UTP Transmission (24-BIT): Full HD (1080p)-40m (130ft) [CAT-5]

HD (720p/1080i)-50m (165ft) [CAT-5]

N/A 8-level digital rotary control

HDMI Equalizartion:

1.2 Volts (peak-to-peak)

Input TMDS Signal:

5 Volts (peak-to-peak, TTL)

Input DDC Signal:

[1] Human body — ±19kV air-gap discharge

ESD Protection:

& ±12kV contact discharge

[2] Core chipset — ±8kV

PCB stack-up 4-layer board

PCB Stack-Up:

(impedance control — differential 100Ω; single 50Ω)

Wall plate mounting

Fixedness:

12V 1A DC at either TX or RX

Power Supply:

1 Watt (max)

Power Consumption:

Operation Temperature: 0~40°C [32~104°F]

-20~60°C [-4~140°F]

Storage Temperature:

20~90% RH (no condensation]

Relative Humidity:

Metal enclosure

Housing:

95mm × 190mm × 80mm

Gross Dimensions:

620 g

Gross Weight:

* Speciﬁ cations are subject to changes without notice.

** For detail, updated Command Code and Application Software, please visit and download from www.abtussingapore.com

MU-CATHD11R/2-06-ST

2×RJ45 + 1×3.5mm

1×HDMI

3.5mm jack for IR receiver

HDMI over CAT-5

Wall Plate Extender

Model: MU-CATHD11T/2-06-ST

(Transmitter)

Caution : Always ensure that the DDC output on the transmitters connected to the

DDC input of the receiver before connecting the power supply. In no circumstances

should a cable be connected on a DDC port at one end and a TMDS port at the

other. Connecting a cable on DDC to TMDS will permanently damage the product.

ABtUS SINGAPORE PTE LTD

Model: MU-CATHD11R/2-06-ST

(Receiver)

Revision 06102015