Airvolution Esatto ERHGC90 User Manual - Page 8

Browse online or download pdf User Manual for Ventilation Hood Airvolution Esatto ERHGC90. Airvolution Esatto ERHGC90 17 pages. Curved glas canopy rangehood 60cm/90cm

Print Page

Through your wall

Further to your various ducting options, below are some

tips on how to correctly duct your rangehood:

–

Always use correctly sized ducting

— DO NOT reduce the size of the ducting

–

Always use solid ducting

–

Always use non-flammable ducting

–

Always duct to the outside atmosphere

–

Do not use flexible ducting

–

Do not duct into the ceiling space- always vent to the

outside atmosphere.

–

Avoid sharp 90 degree bends as much as possible,

use 45 degree bends instead wherever possible

–

Duct to the outside atmosphere using the shortest

duct run possible

–

Use cylindrical ducting whenever possible

Positioning the rangehood

Installation heights

–

Over gas and electric cookers, Esatto

recommends our rangehoods to be mounted

at a height of between 600-800mm above the

cooking surface.

–

Electric cooktops must have a minimum height of

600mm from the underside of the rangehood to the

cooktop face.

–

Gas cooktops must have a minimum of 650mm from

the burner to the underside of the rangedhood.

–

It is not recommended to install the rangehood

outside or over open flame grillers or barbecues.

Installing the rangehood

–

Drill 3 x 8mm holes to accommodate the bracket.

Screw and tighten the bracket onto the wall with

the screws & screw plugs provided.（Fig. 5）.

–

Level up the cooker hood and hang onto the wall

bracket hook. （Fig. 6）

I N S TA L L AT I O N I N S T R U C T I O N S

C O N T I N U E D

–

After hanging the hood on the bracket, remove

the filters, mark 2 holes inside the hood for

safety screws. After marking, remove the hood,

drill two holes and insert 2 wall plugs and finally

fix the safety screws with 2 screws

(ST4x30mm)（Fig. 7）

–

Place the plastic duct on the cooker hood.（Fig.

8）

–

The lower chimney bracket is used to fix the

upper decorative chimney and lower decorative

chimney.

Use 2pcs 4x8mm screws to attach lower

chimney and lower chimney bracket together.

Put the lower chimney on the cooker hood and

mark the location of lower chimney bracket

fixing holes on the wall. Fix the lower chimney

bracket on the wall by 2 screws (4mm x30mm).

（Fig. 9）Noted: Do not fasten screws too

much, make sure upper decorative chimney can

be telescopically adjusted after assembled.

Then pulling out the upper chimney upwards to

–

the target height. Adjust to reach the height

required. Fix the upper chimney on the upper

chimney bracket by 2 screws (4x8mm). Then

fix the upper chimney bracket on the wall.

Before fixing the bracket on the wall, you can

decide the upper chimney bracket fixing holes

for installation（Fig. 10）

Warning

Failure to install the screws or fixing device in

accordance with these instructions may result in

electrical hazards. The warning shall be in the same

part of the instructions that include details of how

to mount the equipment.