Dultmeier Sales DUFB_A-D Owner's Manual - Page 5

Browse online or download pdf Owner's Manual for Washer Dultmeier Sales DUFB_A-D. Dultmeier Sales DUFB_A-D 12 pages. Air pump foam brush system - demand

Print Page

Equipment Placement

1. Select a mounting location on a wall at a height

where the unit can be easily serviced. Hold the

board level and mark spots on the wall for each

mounting hole on the board.

2. Use 5/16" bit to drill 1-1/2" deep holes into the

wall. Hold board on wall and insert 1/4" x 1-7/8"

sleeve anchors (provided) into drilled holes.

Tighten anchor nuts. (Fig. 1)

3. Install boom bumper on end of boom. (Fig. 2-D)

4. To mount boom(s), in bay(s) use the boom bracket

holes for a template. Place the boom bracket

with the single hole on top level against the wall

and mark a spot for each mounting hole. Since

all applications are different, be sure to use the

proper fasteners to secure boom bracket(s) to bay

wall(s). (Fig. 2-E)

5. Slide the top pivot shaft on the boom up into the

top hole of the boom bracket. Slide the bottom

pivot shaft into the right or left hole of the boom

bracket, depending on swing.

6. Place the foam brush manifold as close as possible

to foam brush boom. Run the 3/8" braided hose

from the boom (Fig. 2-H) to the discharge of

manifold. (Fig. 3-H) Secure with clamps.

7. Run 1/4" tubing (provided), from air and chemical

manifolds on Foam Brush System (Fig. 4) to the

foam brush manifold. (Fig. 3-I) Repeat this step

per bay.

8. If you purchased the optional brush holder part

number D627SS, mount the brush holder approx.

60" above floor level. Skip ahead to Step 11.

9. Mount the brush bucket at floor level. The weep

and floor heat system should ensure that the

brush does not freeze. The water will flow over the

bucket and will help keep the brush clean and free

of debris.

10. Position the hose hook on the wall directly above

the center of the foam brush bucket approx. 72"

from floor level. (Fig. 2-F)

11. Connect brush handle to foam brush head.

(Fig. 2-I)

12. Connect hose from boom to brush assembly.

(Fig. 2-G)

Installation & Operating Instructions | 3

Figure 1

Boom

Bracket

Figure 2

Foam Discharge to Boom in bay

Figure 3

Foam Brush Manifold

Figure 4

Air Inlet

Chemical Inlet