Duluth Forge FNVL18-1 Manual - Page 4

Browse online or download pdf Manual for Gas Heater Duluth Forge FNVL18-1. Duluth Forge FNVL18-1 20 pages. Vented natural gas logs

Print Page

WARNING: Any change to

this log set or its controls can

be dangerous.

WARNING: This appliance is

for installation only in a solid-

fuel burning masonry or factory-

built fireplace, constructed of

noncombustible material, and

connected to a working flue.

WARNING: Keep the appli-

ance area clear and free from

combustible materials, gasoline,

and other flammable vapors and

liquids.

1. This appliance, as supplied, is only for

use with the type of gas indicated on the

rating plate. This appliance is convertible

for use with propane/LP, using the manual

ON/OFF safety pilot valve kit.

2. If you smell gas:

• Shut off gas supply

• Do not try to light any appliance

• Do not touch any electrical switches; do

not use any phone in your building

• Immediately call your gas supplier from

a neighbor's phone. Follow the gas sup-

plier's instructions

• If you cannot reach your gas supplier,

call the fire department

3. Never install the log set:

• In a recreational vehicle

• Where curtains, furniture, clothing, or

other flammable objects are less than

42" from the front, top, or sides of the

log set

• In high traffic areas

• In windy or drafty areas

4. Before installing in a solid fuel burning

fireplace, the chimney flue and fire-box

must be cleaned of soot, creosote, ashes

and loose paint by a qualified chimney

cleaner. Creosote will ignite if highly

heated. Inspect chimney flue for damage.

SAFETY

5. You must operate this log set with a fire-

6. Do not allow fans to blow directly into the

7. Do not use a blower insert, heat exchang-

8. This log set needs fresh, outside air

9. Do not run log set

10. Do not burn solid fuel in the fireplace after

11. Log set becomes very hot when in use.

12. Carefully supervise young children when

13. Do not use appliance if any part has been

14. To help prevent breakage, new logs must

15. Turn log set off and let cool before servic-

www.factorybuysdirect.com

place screen in place. Make sure fireplace

screen is closed before running log set. If

the fireplace has glass doors, they must

remain OPEN while this log set is in op-

eration.

fireplace. Avoid any drafts that alter burner

flame patterns. Ceiling fans can create

drafts that alter burner flame patterns.

Altered burner patterns can increase

sooting.

er insert, or other accessory not approved

for use with this log set.

ventilation to run properly. See the Air for

Combustion and Ventilation, page 6.

• where gasoline, flammable liquids and

vapors are used or stored

• under dusty conditions

installing the log set. Do not use this log

set to cook food or burn paper or other

objects.

Keep children and adults away from hot

surface to avoid burns or clothing ignition.

Log set will remain hot for a short time

after shut-down. Allow surface to cool

before touching.

they are in the room with log set.

exposed to or under water. Immediately

call a qualified service technician to in-

spect the room appliance and to replace

any part of the control system (if using

control system) and any gas control which

has been under water.

go through the curing process (see Curing

Logs, page 13).

ing, installing, or repairing. Only a qualified

service person should install, service, or

repair log set.

200247-01A