Danfoss VLT HVAC Drive FC 102 Installation Instructions Manual

Browse online or download pdf Installation Instructions Manual for Controller Danfoss VLT HVAC Drive FC 102. Danfoss VLT HVAC Drive FC 102 6 pages. Igbt module replacement for d1h–d8h drives
Also for Danfoss VLT HVAC Drive FC 102: Operating Manual (16 pages), Installation Manual (20 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (12 pages), Installation Manual (18 pages), Installation Instructions Manual (11 pages), Installation Instructions Manual (8 pages), Installation Instructions Manual (10 pages), Installation Manual (6 pages), Operating Instructions Manual (16 pages), Installation Instructions Manual (6 pages), Installation Manual (16 pages), Installation Manual (8 pages), Instruction Manual (16 pages), Installation Manual (6 pages)

Print Page

Installation Instructions

VLT

Wireless Communication Panel LCP 103

VLT

FC Series FC 102, FC 103, FC 202,

FC 301/FC 302, and LD 302

Items Supplied

•

VLT

Wireless Communication Panel LCP 103.

•

Gasket

Illustration 1.1 VLT

Wireless Communication Panel LCP 103

Compatible Drive Series

NOTICE

Compatible drives have a white USB port.

•

VLT

HVAC Drive FC 102

•

VLT

Refrigeration Drive FC 103

•

VLT

AQUA Drive FC 202

•

VLT

AutomationDrive FC 301/FC 302

•

VLT

Lift Drive LD 302

Compatible software versions

FC 102: 5.10

FC 103: 2.10

FC 202: 3.10

FC 30x: 8.03

Approvals and Certifications

NOTICE

FCC COMPLIANCE NOTICE

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by 1 or more

of the following measures:

•

Modifications: Any modifications made to this device that

are not approved by Danfoss may void the authority

granted to the user by the FCC to operate this equipment.

RF EXPOSURE COMPLIANCE

This portable transmitter with its antenna has shown

compliance with FCC's SAR limits for general population/

uncontrolled exposure. The maximum listed SAR level is 0.22

W/kg (body). The antenna used for this device must not be

co-located or operating in conjunction with any other

antenna or transmitter.

FCC ID: 2ANSELCP-103

Reorient or relocate the receiving antenna.

Increase the separation between the equipment

and receiver.

Connect the equipment into an outlet on a circuit

different from that to which thereceiver is

connected.

Consult the dealer or an experienced radio/

television technician for help.

MI38V402