Dumor EASYCARD SRA3+ User Manual - Page 5

Browse online or download pdf User Manual for Laminator Dumor EASYCARD SRA3+. Dumor EASYCARD SRA3+ 8 pages.

Print Page

Skew

Too low

A B C

If they are correct then its a print shift issue as is the case 95% of the time.

Print shift issues

Symptom

1- All the cards are equally too high

Increase the first cut length

Opposite if too low

2- The image is creeping up the sheet the further down the sheet you go

Increase the card length and / or the gutter cross cut length fractionally

3- The image is creeping down the sheet the further down you go

Decrease the card length and / or the gutter cross cut length fractionally

4- The image moved constantly to one side

Move the infeed side guides in the opposite direction

5- The card spacing is too short

Increase the gutter cut length

6- The card spacing is too long

Decrease the gutter cut length

7- The image on the cards is skewed

No adjustment possible => printer error

Tips to get a good result

- The machine doesn't need cut lines printed on the sheet to cut accurately!!

Do not print them, they just get in the way ....

- If you want to run the colour to the edge of the card do a 3 mm over print bleed so that if there is a minor print position error it will

not be seen as a white edge.

Unjamming

Generally the paper will jam in the infeed side of the blade.

A message jammed will appear along with arrows.

Use the right arrow only to pull the paper back out.

If you use the left arrow the jam will get worse and the drive belt may snap (no warranty).

Too high

A B C

Correct

A B C

(remember the last card cut is at the top of the pile in the tray!!!

)