Danfoss iC7 Series Installation Manual - Page 10

Browse online or download pdf Installation Manual for DC Drives Danfoss iC7 Series. Danfoss iC7 Series 16 pages. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Also for Danfoss iC7 Series: Installation Manual (8 pages), Installation Manual (8 pages), Installation Manual (6 pages), Installation Manual (14 pages), Installation Manual (16 pages), Installation Manual (8 pages), Installation Manual (8 pages), Installation Manual (10 pages), Installation Manual (16 pages), Installation Manual (6 pages), Installation Manual (6 pages), Installation Manual (16 pages), Installation Manual (18 pages)

Print Page
Danfoss iC7 Series Installation Manual
In-bottom/Out-back Cooling Kit for FA11-FA12
Installation Guide
1
2
3
4
5
6
Illustration 8: Installation of Top Cover
1
M5x14 screw
2
Top cover
3
Top gasket
2.6 Assembling the Bottom Duct
The bottom duct is a telescopic duct that collapses to simplify installation. To assemble the duct before installation, use the follow-
ing steps. Refer to
Illustration
Procedure
1.
Cut the strip of ribbed EPDM rubber seal into 2 pieces of 990 mm (39.0 in).
2.
Peel the paper off the self-adhesive seals. Place 1 strip on the outside bottom edge of the inner sleeve of the duct, and
1 strip on the upper inside edge of the outer sleeve of the duct.
10 | Danfoss A/S © 2022.12
9.
4
Top vent
5
M5x12 screw (loosened, not removed)
6
Top of frequency converter
AN361429392581en-000201 / 136R0253
Installation