Danfoss VLT 5000 Series Introduction Manual - Page 5

Browse online or download pdf Introduction Manual for DC Drives Danfoss VLT 5000 Series. Danfoss VLT 5000 Series 9 pages. Frequency converter wobble function
Also for Danfoss VLT 5000 Series: Manual (12 pages), Instruction (4 pages), Instructions Manual (16 pages)

Print Page
Danfoss VLT 5000 Series Introduction Manual

Mapping list

The below listed VLT 3000 parameters in the left column have the corresponding VLT 5000 parameters as
shown in the right column. Please be notify that the opposite is not the case. the 5000 series using the LCP.
VLT 3000 Series
000 Language Select
001 Setup Selection Operation
002 Setup Copy
003 Operation Site
004 Local reference
005 Display Value
006 Local Reset
007 Local stop
008 Local reversing
009 Local Jogging
010 Local reference
011 Reset Energy Counter
012 Reset Hour Counter
014 Power-Up Mode
015 Set-up Selection
100 Load
101 Speed Control
102 Current Limit Control
103 Motor power
104 Motor voltage
105 Motor frequency
106 Automatic motor adaption
107 Motor current
108 Motor magnetizing current
109 Start voltage
110 Start compensation
111 U/f ratio
112 Slip compensation
113 Negative slip compensation
114 Feedback type
115 Display Value at min. Feedback
116 Display Value at max. Feedback
117 Feedback Type
121 Proportional Gain
122 Integral Time
123 Differentiation Time
124 Low Pass Filter
MG.50.Q2.02 – VLT is a registered Danfoss trade mark
VLT
®
3000 to 5000 converter
VLT 5000 series
001 Language
004 Active Setup
006 Copying of Setups
002 Local/remote Control
Not available via serial com.
008 Display Scaling of Motor Frequency
017 Local Reset of Trip
Not available via serial com.
Not available via serial com.
015 Local Jog
Not available via serial com.
618 Reset of kWh Counter
619 Reset of Hour-Run Counter
019 Operating State at Power-Up, Local
005 Programming Set-up
101 Torque characteristics
100 Configuration
308, 311 and 314, Analogue input function
102 Motor power
103 Motor voltage
104 Motor frequency
107 Automatic motor adaption
105 Motor current
No valid parameter
No valid parameter
No valid parameter
No valid parameter
No valid parameter
No valid parameter
308, 311 and 314, Analogue input function
414 Minimum Feedback
415 Maximum Feedback
416 Reference/feedback Unit
440 Process PID Proportional Gain
441 Process PID Integral Time
442 Process PID Differentiation Time
444 Process PID Low Pass Filter
5