Danfoss VLT AutomationDrive FC 302 Installation Instructions Manual - Page 5

Browse online or download pdf Installation Instructions Manual for DC Drives Danfoss VLT AutomationDrive FC 302. Danfoss VLT AutomationDrive FC 302 12 pages. Igbt module replacement for d1h–d8h drives
Also for Danfoss VLT AutomationDrive FC 302: Operating Manual (16 pages), Installation Manual (20 pages), Installation Instructions (4 pages), Installation Instructions Manual (6 pages), Installation Manual (18 pages), Installation Instructions Manual (8 pages), Installation Instructions Manual (10 pages), Installation Manual (6 pages), Installation Manual (16 pages), Operating Instructions Manual (16 pages), Installation Instructions Manual (6 pages), Installation Manual (16 pages), Installation Manual (8 pages), Installation Instructions Manual (6 pages), Installation Manual (6 pages)

Print Page

Installation Instructions

Install the left and right brake terminals onto the brake terminal bracket using 4 M5 nuts. Torque to 2.3 Nm (20 in-lb).

Secure the brake terminal assembly to the AC bus bar assembly support with 2 M8 nuts. Torque to 9.6 Nm (85 in-lb). Refer

to Illustration 1.6.

Install the mains bus bar S-bracket to the AC bus bar assembly support bracket using 2 M5 nuts. Torque to 2.3 Nm

(20 in-lb).

AC bus bar assembly support bracket

Mounting point for lower EMI/EMC shield

Brake terminal assembly (terminals and bracket)

Illustration 1.6 Assembling the AC Bus Bar Subassembly Bracket

Assemble the motor bus bar subassembly using 9 stand-offs and 9 M5 nuts. Torque to 2.3 Nm (20 in-lb).

Refer to Illustration 1.7.

Slotted opening for M10 screw

Stand-offs (front and back side of bus bar), indicated by an S in

the drawing

Illustration 1.7 Assembling the Motor Bus Bar Subassembly

MI92I102

Bus Bar Kit for 6-pulse, 2-drive System

VLT® Series FC 102, FC 202, and FC 302

M5 nut

Mains bus bar S-bracket

Studs that insert into the side support bracket

M5 nut

Solid motor bus bars