DUNE HD CENTER Quick Manual - Page 6

Browse online or download pdf Quick Manual for Media Player DUNE HD CENTER. DUNE HD CENTER 8 pages.
Also for DUNE HD CENTER: Quick Start Manual (19 pages)

Print Page

Connection to a TV set with HDMI/DVI output:

Since Dune HD Center is designed first of all for playback of high definition (HD) video (up to

1080p), the best way of signal transmission from player to a TV set or projector is the HDMI

interface. In this case, video and audio streams are transmitted in digital form, without

losses, allowing enjoying excellent picture and sound. It is recommended to connect the

player to any compatible equipment using original DUNE HDMI cable (option).

 If your TV set has no HDMI socket, but it is equipped with DVI one, you can use an original DUNE

HDMI-DVI adapter (to be connected to HDMI-HDMI cable) or Dune HDMI-DVI cable (no adapter

needed). In this case, transmission of audio stream is only available separately, from an analog

audio or digital optical output.

1) Make sure that the player and the TV set are

switched off. Do not switch on until the end of

connection procedure.

2) Connect the HDMI output of the player with

appropriate HDMI/DVI input of the TV set using

a HDMI-HDMI cable for HDMI input of your TV

set, or HDMI-DVI cable or HDMI-HDMI cable

with HDMI-DVI adapter, for DVI input of your

TV set.

3) Using RC of TV or projector (depending on

what you use), select required input and display

mode. For more instructions please refer to the

manual of your displaying equipment.

4) Wait until you see a picture on screen of your TV (or projection) set received from the player.

Connection to a TV set with component video signal

input (Component Video, Y, Cb, Cr)

For this connection you should use a 3RCA-3RCA video cable and (optionally) a 2RCA-

2RCA audio cable for sound transmission to your TV set. Please note that video cable

shall have an impedance of 75 Ohm, i.e. specially fitted for transmission of analog video

signal.

1) Make sure that the player and TV set are

switched off. Do not switch on until the end

of connection procedure.

2) Connect the component video output of

media player with relevant TV input using a

3RCA-3RCA cable.

3) Optionally connect audio output AUDIO L

R of the player with relevant input of TV set

using a 2RCA-2 RCA cable (note: you can

use optical cable to transmit digital audio

to your A/V receiver; this way better audio

quality result may be expected).

4) Using RC of TV or projector (depending

on what you use), select required input

and display mode. For more instructions

please refer to the manual of your displaying

equipment.

HDMI IN

AUDIO IN

COMPONENT

VIDEO IN